Table of Contents
2.3
Parent Unit Power Supply
IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended. This will allow the unit to operate on battery in the event of a
power failure.
1.
Connect the small plug of the power adapter to the parent unit and the
other end to a suitable mains power socket.
adapter (5V
DC / 600mA) with the slightly smaller DC plug.
2. Press and hold the
the parent unit.
3. Once the baby and parent units are switched on, the display on the parent
unit will show the video captured by the baby unit.
4. If there is no connection or you are out of range, the video display will go
off,
and the unit
the baby unit until
5. Press and hold the
finishes scrolling, to turn OFF the parent unit.
NOTE
The battery icon
a beep every 16 seconds. The battery needs to be recharged. The battery pack
takes about 12 hours to charge fully.
When charging
1. During power OFF, when adapter is plugged in, a adapter logo will display
on screen and then a flashing battery logo will display for 45 sec. The Blue
LED at top left corner light up indicates adapter is plugged in.
10
P
POWER ON/OFF button for 1 second to turn ON
will beep every 5 seconds. Move the parent
the link is re-established.
P
POWER ON/OFF button, until the progress bar
turns RED to indicate that the battery is low, and it gives
Only use the enclosed power
unit closer to
Getting Started
Table of Contents
