Current Time Setting; Auto Mode Operation - Mitsubishi Heavy Industries SRF35ZS-W User Manual

■ When inserting the batteries, the current time is automatically set to time setting mode. Mon and 13:00 are displayed as the current time.

Set a correct day of the week and a time.

NOTE

The timer operation works based on the time clock, so please

set it correctly.

The remote control data is reset when the present time is set.

■ Automatically selects the operation mode (COOL, HEAT) depending on the room temperature when switched on.

Example: Set to Sat 10:30.

1

Press the TIME SET UP switch.

Press with the tip of a ballpoint pen, etc.

The day of the week display blinks, enabling the setting of a day of the week.

2

Press the " or

(Set to Sat)

3

Press the SET button.

The day of the week display changes from blinking to steady lighting, com-

pleting the setting of a day of the week, and the time display blinks.

Make sure to press the button within 60 seconds from the last operation in

step 2, otherwise the day of the week is not set.

4

Press the " or

(Set to 10:30)

5

Press the SET button.

The time display changes from blinking to steady lighting and the setting is

complete.

Make sure to press the button within 60 seconds from the last operation in

step 4, otherwise the time is not set.

1

2

NOTE

In case air is not blowing out

during the operation.

Page 31

When the included clean lter is

installed the air-conditioner will

clean the air during automatic

operation.

EN-12

(TIMER)" button.

(TIMER)" button.

When the battery of the remote control is replaced or the ACL

switch is pressed, the remote control is set to the initial state.

Since the WEEKLY TIMER program is not set in the initial state,

set the program according to the setting procedure.

Press the MODE button.

The mode changes whenever the button is pressed.

Set to

.

Press the ON/OFF button.

To stop:

Press the ON/OFF button.

AUTO mode can be

operated by simply

pressing the ON/OFF

button.

If you do not want the AUTO mode program, change to

COOL, HEAT or FAN instead of AUTO.

Air ow direction adjustment procedure.

Page 14

Page 15