Table of Contents
Keyboard Stand Assembly
Assembly Precautions
CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct orientation. Please assemble the unit in
accordance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Assemble the unit on a hard and flat floor with ample space.
• Be sure to use the correct screw size, as indicated below.
Use of incorrect screws can cause damage.
• Be sure to tighten all screws upon completing assembly of
the unit.
• To disassemble, reverse the assembly sequence given
below.
Have a Phillips-head (+) screwdriver of the appropriate size
ready.
Keyboard Stand Assembly
Reference page
YDP-164, YDP-144
YDP-S54
After completing the assembly, please
check the following.
• Are there any parts left over?
Review the assembly procedure and correct any errors.
• Is the instrument clear of doors and other
movable fixtures?
Move the instrument to an appropriate location.
• Does the instrument make a rattling noise
when you shake it?
Tighten all screws.
• Does the pedal box rattle or give way when you
step on the pedals?
Turn the adjuster so that it is set firmly against the floor.
• Are the pedal and power cords inserted
securely into the sockets?
Check the connection.
page 34
page 37
When Moving the Instrument After
Assembly
CAUTION
• When moving the instrument after assembly, always hold
the bottom of the main unit.
• Do not hold the key cover or top portion. Improper handling
can result in damage to the instrument or personal injury.
NOTICE
Rotate the adjuster under the pedal until it separates from the
floor surface. Contact with the adjuster can result in damage
to the floor surface.
Key cover
Hold here.
Separate the adjuster
from the floor surface.
Transporting
If you move to another location, you can transport the
instrument along with other belongings. You can move
the unit as it is (assembled), or you can disassemble the
unit down to the condition it was in when you first took
it out of the box. Transport the keyboard horizontally. Do
not lean it up against a wall or stand it up on its side. Do
not subject the instrument to excessive vibration or
shock. When transporting the assembled instrument,
make sure all screws are properly tightened and have not
been loosened by moving the instrument.
CAUTION
If the unit creaks or is otherwise unsteady when you play
on the keyboard, refer to the assembly instructions and
retighten all screws.
YDP-164, YDP-144, YDP-S54 Owner's Manual
Do not hold here.
Top portion
33
Table of Contents
