Dormakaba RCI 910TC-WRB Installation

INSTALLATION

The remote module allows wireless activation of the 910TC button for convenience or installations that do not allow for wire access.

1. Remove power to the unit prior to installing the remote

receiver. (Fig.1)

Fig. 1

2. Insert the pins of the remote board into the header of the button

as indicated below. Ensure the pins are aligned and fully engaged in

the header. (Fig.2)

Fig. 2

3. Reapply power to the unit.

4.Once installed the transmitter and receiver must be paired to each

other for proper operation.

IS910TC-WRM-WRB

© 2018 dormakaba Canada Inc.

www.rutherfordcontrols.com • Phone: 1.800.265.6630 • Fax: 1.800.482.9795 • Email: [email protected]

Remote Receiver and Remote Transmitter

5. On the back of the remote board, locate the button and LED as

indicated below. (Fig.3)

Fig. 3

6. Press and hold the button on the board until the red LED comes

on, then release.

7. While the LED is lit press the button on the transmitter (Fig. 4),

the LED will blink indicating the code is being stored.

Fig. 4

8. The red LED will go out to indicate the storing of the code has

been successful. Up to 5 transmitters can be paired with one

receiver by following the above process. NOTE: Should you need to

reprogram or delete a transmitter, all transmitters will be erased and

need to be reprogrammed individually.

9. To erase all units, press and hold the button on the back of the

board until the red LED comes on. Continue to hold the button until

the LED goes out.

10. Repeat steps 6-8 to reprogram

910TC-WRB

R03-18TG-4