LG 55SH7E Owner's Manual
Monitor signage
Hide thumbs
Also See for 55SH7E:
- Owner's manual (135 pages) ,
- Easy setup manual (8 pages) ,
- Quick start manual (8 pages)
Table of Contents
Quick Links
Table of Contents
Related Manuals for LG 55SH7E
Summary of Contents for LG 55SH7E
- Page 1 LG Digital Signage (MONITOR SIGNAGE) Please read this manual carefully before operating your set and retain it for future reference. 43SH7E 32SM5E 32SM5KE 49SH7E 43SM5E 43SM5KE 55SH7E 49SM5E 49SM5KE 55SM5E 55SM5KE www.lg.com Copyright © 2018 LG Electronics Inc. All Rights Reserved.
-
Page 2: Table Of Contents
- Connecting the Stand ..........14 - Connecting the Speakers ..........16 - Connecting the IR Sensor .........19 - Portrait Layout ..............20 - Attaching and removing the LG Logo Bracket ................21 - Installing on a Wall ............23 REMOTE CONTROL ....25 MAKING CONNECTIONS ... 27 - Connecting to a PC............27... -
Page 3: Safety Precaution
WARNING: This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment may cause radio interference. SAFETY PRECAUTION Please read these safety precautions carefully before using the product. WARNING If you ignore the warning message, you may be seriously injured or there is a possibility of accident or death. CAUTION If you ignore the caution message, you may be slightly injured or the product may be damaged. - Page 4 If you install the product in a place that does not meet the recommended conditions, this may cause serious damage to the product’s picture quality, life cycle, and appearance. Please check with LG or a qualified installer before installing. This caution applies to a place where there is an abundance of fine dust or oil mist, chemical substances are used, the temperature is very high or low, the humidity is very high, or the product is likely to remain turned on for a long period of time (airport and train station), failure to do so will invalidate the warranty.
-
Page 5: Precautions To The Ac Adapter And Electrical Power
- If loosely connected, the poor connection may cause a fire or electric shock. • Be sure to use power cords and AC adapters provided or approved by LG Electronics, Inc. - The use of non-approved products may cause a fire or electric shock. - Page 6 • Do not touch the power plug with wet hands. Additionally, if the cord pin is wet or covered with dust, dry the power plug completely or wipe dust off. - You may be electrocuted due to excess moisture. • If you don’t intend to use the product for a long time, unplug the power cable from the product.
-
Page 7: Precautions In Moving The Product
Precautions In Moving the Product WARNING • Make sure to turn off the product. - You may be electrocuted or the product can be damaged. • Make sure to remove all cables before moving the product. - You may be electrocuted or the product can be damaged. •... -
Page 8: Mounting On A Wall
CAUTION • Do not put or store inflammable substances near the product. - There is a danger of explosion or fire due to careless handling of the inflammable substances. • When cleaning the product, unplug the power cord and scrub gently with a soft cloth to prevent scratching. Do not clean with a wet cloth or spray water or other liquids directly onto the product. -
Page 9: Licenses
LICENSES Supported licenses may differ by model. For more information of the licenses, visit www.lg.com. The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. in the United States and other countries. -
Page 10: Assembly And Preparation
SuperSign Software & Manual - Downloading from the LG Electronics website. - Visit the LG Electronics website (http://partner.lge.com) and download the latest software for your model. • The warranty will not cover any damage caused by using the product in an excessively dusty environment. - Page 11 Speaker kit (Only for **SM5E model) Screws Screws Speakers Cable holder/ Diameter 4.0 mm x Pitch 0.7 Diameter 4.0 mm x Pitch 1.6 mm Cable Tie mm x Length 8 mm SP-5000 x Length 10 mm (including spring washer) Media Player kit Media Player Screws CD (Owner's Manual)/ Cards...
-
Page 12: Parts And Buttons
Parts and Buttons The image may be different according to the model. Buttons • : Changes the input source. • : Accesses the main menus, or saves your input and exits the menus. • : Adjust the up and down. •... -
Page 13: Assembling The Memory Cover
Assembling the Memory Cover Assemble the cover with a screw as illustrated to prevent the USB memory from theft. -
Page 14: Connecting The Stand
Connecting the Stand - For certain models only. - The image may be different according to the model. 32SM5*... - Page 15 43/49/55SH7E, 43/49/55SM5*...
-
Page 16: Connecting The Speakers
Connecting the Speakers - For certain models only. - The image may be different according to the model. 32SM5E Connect an input signal cable before installing the speakers. Mount the speakers by using screws as shown below. Make sure the power cable is disconnected before making a connection. - Page 17 Then connect the speaker cable. After installing your speakers, use holders and cable ties to organize the speaker cables. Basic installation Installation with OPS connected...
- Page 18 43/49/55SM5E Connect an input signal cable before installing the speakers. Mount the speakers by using screws as shown below. Make sure the power cable is disconnected before making a connection. Then connect the speaker cable. After installing your speakers, use holders and cable ties to organize the speaker cables.
-
Page 19: Connecting The Ir Sensor
Connecting the IR Sensor When you connect the cable to the product, the feature for receiving remote control signals is activated. Rotate the IR sensor according to the screen orientation (Landscape/Portrait). - The image may be different according to the model. Basic installation [Front] [Rear]... -
Page 20: Portrait Layout
Portrait Layout When installing in a portrait layout, rotate the monitor counterclockwise 90 degrees (when facing the screen). Using Kensington Lock (This is not available for all models.) The Kensington security system connector is located at the back of the monitor. For more information on installation and use of this system, refer to the manual provided with the Kensington security system or visit http://www.kensington.com. -
Page 21: Attaching And Removing The Lg Logo Bracket
LG Logo Bracket to the bottom rear of the monitor. LG Logo Bracket After removing the screw, remove the LG Logo Bracket. When re-attaching the LG Logo Bracket, repeat the process in reverse order. - Page 22 LG Logo Bracket to the bottom rear of the monitor. After removing the screw, remove the LG Logo Bracket. Attach the LG Logo Bracket with a screw, aligning it with the hole on the right side.
-
Page 23: Installing On A Wall
Screws which are longer than standard length may damage the inside of the monitor. A non-VESA standard screw may damage the product and cause the monitor to fall. LG Electronics is not liable for any accidents related to the use of non-standard screws. - Page 24 Disconnect the power cord before moving or installing the monitor to avoid risk of electric shock. • If you install the monitor on a ceiling or slanted wall, it may fall and result in injury. Use an authorized LG wall mount and contact your local dealer or qualified personnel to assist with the installation.
-
Page 25: Remote Control
REMOTE CONTROL The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully to use the monitor correctly. To install batteries, open the battery cover, place batteries (1.5 V AAA) matching terminals to the labels inside the compartment, and close the battery cover. To remove the batteries, perform the installation actions in reverse. - Page 26 Selects the Picture Mode. (HOME) Activates the Launcher. Enters the White Balance menu. (SETTINGS) Accesses the main menus or saves your input and exit menus. SuperSign menu key. Navigation Buttons Scrolls through menus or options. Selects menus or options and confirms your input. (BACK) Allows you to move back one step in the user interaction function.
-
Page 27: Making Connections
MAKING CONNECTIONS You can connect various external devices to your monitor. Change the input mode and select the external device you want to connect. For more information about external device connections, see the user manual provided with each device. Connecting to a PC Some of the cables are not provided. - Page 28 NOTE • For the best image quality, using the monitor with HDMI connection is recommended. • To comply with the specifications of the product, use a shielded interface cable with ferrite core, such as a D-sub 15- pin cable and DVI-D/HDMI cable. •...
-
Page 29: Using The Input List
Using the Input List (HOME) → • HDMI1 → HDMI2 → HDMI3/OPS/DVI-D → DISPLAYPORT... -
Page 30: Troubleshooting
TROUBLESHOOTING No image is displayed. Problem Action Is the product power cord connected? • Check if the power cord is correctly plugged into the power outlet. Does the “Invalid Format” message • The signal from the PC (Graphics card) is out of the vertical or appear? horizontal frequency range of the product. - Page 31 After-image appears on the product. Problem Action After-image appears when the product is • If you use a fixed image for a long time, the pixels may be damaged. turned off. Use the screen-saver function. • When a dark image is displayed on the screen after an image with high contrast (black and white or gray), this may cause image sticking.
- Page 32 CAUTION • Image sticking does not occur when using constantly changing images but may occur when using a fixed image for an extended period of time. Therefore, it is recommended that you use the instructions below to decrease the likelihood of image sticking occurring when using a fixed image.
-
Page 33: Product Specifications
PRODUCT SPECIFICATIONS The product specifications below may be changed without prior notice due to upgrade of product functions. “ ” refers to alternating current (AC), and “ ” refers to direct current (DC). LCD screen Screen type Thin Film Transistor (TFT) Liquid Crystal Display (LCD) Screen Video signal Maximum resolution... - Page 34 1102.2 mm x 638.5 mm x 54 mm / 14.3 kg x Depth) /Weight Head + Stand 1102.2 mm x 696.8 mm x 219.6 mm / 17.6 kg 55SH7E LCD screen Pixel pitch 0.630 mm (H) X 0.630 mm (V)
- Page 35 43SM5E LCD screen Pixel pitch 0.4902 mm (H) X 0.4902 mm (V) Power Rated power AC 100-240 V ~ 50/60 Hz 0.9 A Power consumption On Mode: 75 W (Typ.) Sleep Mode: ≤ 0.5 W Off Mode: ≤ 0.5 W Dimensions (Width x Height Head 969.6 mm x 563.9 mm x 38.6 mm / 9.8 kg...
- Page 36 32SM5KE LCD screen Pixel pitch 0.36375 mm (H) X 0.36375 mm (V) Power Rated power AC 100-240 V ~ 50/60 Hz 0.8 A Power consumption On Mode: 60 W (Typ.) Sleep Mode: ≤ 0.5 W Off Mode: ≤ 0.5 W Dimensions (Width x Height Head 729.4 mm x 428.9 mm x 60.5 mm / 5.4 kg...
- Page 37 Wireless module (LGSBWAC72) Specifications Wireless LAN (IEEE 802.11a/b/g/n/ac) Frequency range (MHz) Output power (Max.) (dBm) 2400 to 2483.5 5150 to 5725 16.5 5725 to 5850 (Not for EU) 11.5 Bluetooth Frequency range (MHz) Output power (Max.) (dBm) 2400 to 2483.5 •...
- Page 38 HDMI / DVI-D / DISPLAYPORT / OPS (PC) Support Mode Resolution Horizontal frequency (kHz) Vertical frequency (Hz) Remarks 800 x 600 37.879 60.317 1024 x 768 48.363 1280 x 720 44.772 59.855 1366 x 768 47.7 1280 x 1024 63.981 60.02 1680 x 1050 65.290...
- Page 39 This product qualifies for ENERGY STAR®. Changing the factory default configuration and settings or enabling certain optional features and functionalities may increase energy consumption beyond the limits required for ENERGY STAR® certification. Refer to ENERGYSTAR.gov for more information on the ENERGY STAR®...