Table of Contents
Quick Links
Table of Contents
Related Manuals for Samsung SSA-R2000V
Summary of Contents for Samsung SSA-R2000V
- Page 1 RFID Reader User Manual SSA-R2000V...
- Page 2 Techwin. Disclaimer Samsung Techwin makes the best to verify the integrity and correctness of the contents in this document, but no formal guarantee shall be provided. Use of this document and the subsequent results shall be entirely on the user’s own responsibility. Samsung Techwin reserves the right to change the contents of this document without prior notice.
- Page 3 If this product fails to operate normally, contact the nearest service center. Never disassemble or modify this product in any way. (SAMSUNG is not liable for problems caused by unauthorized modifi cations or attempted repair.) . When cleaning, do not spray water directly onto parts of the product. Doing so may cause fi re or electric shock.
- Page 4 safety information FCC Statement Caution : Any changes or modifi cations in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.
-
Page 5: Table Of Contents
contents Features PRODUCT INTRODUCTION What’s included At a Glance Cable Color Scheme Cable Selection INSTALLATION AND EXTERNAL Installation Precautions on installation CONNECTION External Connection INITIALIZATION Basic Operations OUTPUT FORMAT Wiegand Output RS-232 Output 8 Bit Burst Output Format TROUBLESHOOTING Troubleshooting PRODUCT SPECIFICATIONS Product Specifi... -
Page 6: Features
Reverse Polarity Protection ◆ Weatherproof and Dustproof WHAT’S INCLUDED Check if the following items are included in the product package. SSA-R2000V 3.5 x 40mm Screws (x4) Product 3.5 x 25mm Screws (x4) CD Manual 6 x 30mm Plastic Anchor (x4... -
Page 7: At A Glance
AT A GLANCE Front/Rear SSA-R2000V Displays the status of the system operation. Keypad Used to enter the ID/password. Tamper Switch A tamper switch to detect falling from the wall. Connection Cable Used to connect to the power source or I/O cable. -
Page 8: Cable Color Scheme
product introduction CABLE COLOR SCHEME Item Cable Color Signal Line Description DC +12V Power (+12V) Power Black Earth-grounding for power Green WIK_DATA0 Wiegand Data 0 Output Port White WIK_DATA1 Wiegand Data 1 Output Port Output Purple TX_OUT Orange RS-232 GND Not used Brown Yellow... -
Page 9: Installation
99.80 6-32 or M3 Screws 8.7cm 93.00 91.50 86.50 85.50 1/2˝ hole 81.80 4.35cm 72.50 6.4cm 6-32 hole 54.50 36.50 Reader Module 26.23 SSA-R2000V 18.50 Bezel 6.00 0.00 64.00 3mm Hex Wrench [Figure 1] [Figure 2] English _ 9... -
Page 10: Precautions On Installation
installation and external connection PRECAUTIONS ON INSTALLATION IF INSTALLING ON A METAL WALL If you install the reader on a metal wall, the read range may be reduced. To avoid this problem, it is recommended to insert the spacer between the metal wall and the reader as shown below. -
Page 11: External Connection
EXTERNAL CONNECTION WIRING DIAGRAM SSA-R2000V Wiegand Data 0 Out Green Wiegand Data 1 Out White Tamper Switch Out(NC) Light yellow RS-232(TX) Tamper Switch Out(COM) Pink Purple CONTROLLER Buzzer Control In Blue RS-232(GND) Orange LED Control In(Green) Yellow LED Control In(Orange) -
Page 12: Basic Operations
When it is done, the green indicator turns off and for receiving the next card, the red indicator stays ON. SSA-R2000V Using the keypad Hold down the keypad until you hear a beep. The reader transfers the keypad data to the controller. -
Page 13: Wiegand Output
output format WIEGAND OUTPUT Timing Diagram 100us DATA-0 DATA-1 n *n : 34 or26 LOGIC Data Type (26-bit) • Bit 1 : Even Parity (bit 2 ~ bit 13) • Bit 2 ~ 9 : Facility Code (000 ~ 255) •... -
Page 14: Rs-232 Output
output format RS-232 OUTPUT Output Waveform +15V Space(=0) Indeterminate Region Mark(=1) 8 Data Bits -15V 2 Stop Bits Start Bit Data packet corresponding to ASCII character ‘A’ Data Type START (0X02H) DATA (8 Char) END (0x03H) START(0X02H) DATA (1~8 Char) END (0x03H) ... -
Page 15: Bit Burst Output Format
8 BIT BURST OUTPUT FORMAT 8Bit Burst Output Format Keypads Binary Hexa Keypads Binary Hexa 11110000 10010110 11100001 10000111 11010010 01111000 11000011 01101001 10110100 01011010 10100101 01001011 English _ 15... -
Page 16: Troubleshooting
Check the rated voltage specifi ed in the user manual and the catalog. Ensure that the card must comply with the PSK (125KHz) format provided by Samsung. - Cards of 13.56MHz format can not be used. (Contact the card retailer regarding the card format.) 3) If the problem persists, contact the nearest customer service for your assistance. -
Page 17: Product Specifi Cations
PRODUCT SPECIFICATIONS Item SSA-R2000V Power / Current DC 12V / Max.230mA Reading Time (Card) 30ms Input Port 2 ea : External LED Control, External Buzzer Control Output Port 26bit Wiegand, 8bit Burst for PIN (Selectable) LED Indicator... - Page 18 TEL : +82-70-7147-8740~60 FAX : +82-31-8018-3745 SAMSUNG TECHWIN AMERICA Inc. SAMSUNG TECHWIN EUROPE LTD. 1480 Charles Willard St, Carson, CA 90746, UNITED STATES Samsung House, 1000 Hillswood Drive, Hillswood Business Tol Free : +1-877-213-1222 FAX : +1-310-632-2195 Park Chertsey, Surrey, UNITED KINGDOM KT16 OPS www.samsungcctvusa.com TEL : +44-1932-45-5300 FAX : +44-1932-45-5325 www.samsungsecurity.com...