Rear Cover - HP Z34c G3 Maintenance And Service Manual

Disassembly procedure

S1

1) Disassemble RC from the monitor and pull out BTN BD wire from the Main BD.

S2

1) Unlock 6 screws and disassemble Hinge from the SHD as the picture 1.

2) Tear off the TOP Mylar, interface Mylar and Right Mylar from the SHD as the

picture 1.

3) Pull out sensor BD cable and camera wire from the Main BD as the picture 2.

4) Disassemble sensor BD from the camera and pull out sensor BD cable from the

sensor BD as the picture 2.

5) Tear off conduct tape and then pull out LENS BD wire and SPK wire from the

Main BD as the picture 3.

6) Unlock 5 screws from the SHD as the picture 3.

7) Tear off the long acetate tapes and pull out the FFC, EDP and driver BD wire

from the Main BD.

PICTURE 1

PICTURE 1

13