Table of Contents
ENGLISH
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge
u
nonrechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
u
placed in a well ventilated area when
charging.
Electrical safety
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate. Never attempt to
replace the charger unit with a regular
mains plug.
Symbols on the charger
Read all of this manual carefully
before using the appliance.
This tool is double insulated;
#
therefore no earth wire is
required. Always check that the
power supply corresponds to
$
the voltage on the rating plate.
The charging base is intended
for indoor use only.
Labels on appliance
The following symbols appear on this ap-
pliance along with the date code.
6
(Original instructions)
Read all of this manual care-
fully before using the appli-
ance
Only use with charger
S003AQS1500015
S003AQS1500015
Features
This tool includes some or all of the following features.
1. On/Off switch
2. Main handle
3. Dust bowl
4. Extendable extra wide nozzle
5. Crevice nozzle accessory
6. Brush accessory
7. Charger jack plug (HLVC315J11 and HLVC320J11 only)
8. Charger Base (HLVC315B11 and HLVC320B11 only)
Operation (Fig. A)
To turn on slide the On/Off switch (1) forward as shown in
u
figure A.
Slide the On/Off switch backward, the appliance stops
u
working.
Using the Extendable wand (Fig. B, C)
Slide the extra wide nozzle (4) from out of the dust bowl
u
(3) as shown in figure B.
Rotate the two end pieces to form the vacuuming head as
u
illustrated in figure C.
Rotate the two wings closed and then push nozzle back
u
into place.
Note: If the extendable tool pulls completely out from the dust
bowl it can be pressed back in and will lock into positon.
Attaching Accessories
If you need to use the accessory brush (6), insert the
u
brush into the air inlet as shown in figure D and then start
the appliance.
If you need to use the accessory crevice nozzle (5), insert
u
the crevice nozzle into the air inlet as shown in figure D
and then start the appliance.
Charging (Fig. E, F)
Charging the battery via charger base
(HLVC315B11 and HLVC320B11 only) (Fig. F)
Make sure that the appliance is switched off. The battery
u
will not be charged with the on/off switch (1) pressed.
Place the appliance on the charging bracket (8).
u
Plug in the charger. Switch on at the mains.
u
Table of Contents
