Page 1
Composite place into the appropriate recycling bin. 3” Cut Off Tool 07204 FOR HELP OR ADVISE ON THIS PRODUCT PLEASE CONTACT YOUR DISTRIBUTOR, OR SIP DIRECTLY TEL: 01509500400 EMAIL: [email protected] or technical@sip- Please read and fully understand the in- group.com...
Page 2
LE12 9NH England As the manufacturer's authorised representative within the EC declare that the Composite 3” Cut Off Tool - SIP Part. No. 07204 Conforms to the requirements of the following directive(s), as indicated. 2006/42/EC Machinery Directive And the relevant harmonised standard(s) Signed: …………………………………...
Page 3
PARTS LIST CONTENTS Ref. No. Description SIP Part No. Ref. No. Description SIP Part No. Bolt AI05-00410 Back plate AI05-00426 Washer AI05-00411 Bearing AI05-00427 Disc 07591 Rubber ring AI05-00428 Fixed seat AI05-00413 Housing AI05-00429 Front sheath AI05-00414 Noise reduction nut AI05-00430 Disc guard AI05-00415...
Page 4
SAFETY INSTRUCTIONS EXPLODED DRAWING IMPORTANT: Please read the following instructions carefully, failure to do so could lead to serious personal injury and / or damage to the cut off tool. When using your cut off tool, basic safety precautions should always be followed to reduce the risk of personal injury and / or damage to it.
Page 5
TROUBLESHOOTING SAFETY INSTRUCTIONS….cont The compressed air supply MUST be at a suitable regulated pressure. Pipe work, reg- The following form lists the common operating issues with problems and solutions. ulators, hoses, isolation valves and connection devices MUST be suitable for the in- Please read the form carefully and follow it.
Page 6
SAFETY INSTRUCTIONS….cont OPERATING INSTRUCTIONS….cont OPERATING THE CUT OFF TOOL We recommend wearing a face mask or respiratory equipment when Once the disc is fitted and secure: using any air tool; particularly during drilling, sanding, grinding, sawing or other operations likely to cause airborne particles. Connect the drill to the air supply via the air inlet (6).
Page 7
OPERATING INSTRUCTIONS….cont GETTING TO KNOW YOUR COMPOSITE AIR CUT OFF TOOL LUBRICATION An automatic in-line filter-regulator-lubricator is recommended (Fig.1) as it in- creases tool life and keeps the tool in sustained operation. The in-line lubricator should be regularly checked and filled with air tool oil. Proper adjustment of the in-line lubricator is performed by placing a sheet of paper next to the exhaust ports and holding the throttle open for approximately 30 seconds.
Page 8
TECHNICAL SPECIFICATIONS OPERATING INSTRUCTIONS DESCRIPTION SIP Part No. 07204 This 3” cut off tool is designed with a durable lightweight composite housing. It has a Disc Ø 3” (76.2mm) variable speed trigger / throttle for precise start-up and control, handle mounted ex- Disc Bore 3/8”...