Table of Contents
Quick Links
Table of Contents
Related Manuals for Conlog BEC21
Summary of Contents for Conlog BEC21
-
Page 2: Table Of Contents
Contents Introduction ................................3 Disclaimer ................................3 Safety Information ..............................3 Safety and Maintenance Instructions ........................4 Installation ................................5 Diagrams and Illustrations..........................5 Procedure ................................6 Testing the Meter Installation and Sealing the Device ................... 7 Cabling Specifications ............................. 7 Display Messages .............................. -
Page 3: Introduction
Electrical equipment should be installed, operated, serviced and maintained only by a qualified installation electrician or an Electrical Contractor. No responsibility is assumed by Conlog (Pty) Ltd for any consequences arising out of the use of this material. An installation electrician or electrical contractor is one who has skills and knowledge related to the installation, and operation of the electrical equipment has received safety training to recognize and avoid the hazards involved. -
Page 4: Safety And Maintenance Instructions
Safety and Maintenance Instructions Do not use product if physical or liquid damage is present. Contact your local supply authority for assistance. The wiring must be performed by a certified installation electrician and must conform to the prevailing government standards and safety regulations. This product is not a protection device and so requires the use of a suitable upstream breaker e.g. -
Page 5: Installation
Installation Diagrams and Illustrations Figure 1: Product Layout Figure 2: Terminal Cover Remove terminal screw before mounting the meter and insert the terminal screw on to the terminal cover. Figure 3: Terminals Figure 4: Mounting... -
Page 6: Procedure
Procedure 1. Before setting up the appliance, check it for any externally visible damage. Under no circumstances should you use a damaged appliance. A damaged appliance could be dangerous 2. Remove Terminal Tamper cover (Figure2) 3. Mark wall and drill mounting holes (Figure 4) 4. -
Page 7: Testing The Meter Installation And Sealing The Device
Testing the Meter Installation and Sealing the Device To test the installation: 1. Ensure that the Meter is correctly installed. 2. Apply power to the meter by closing the upstream breaker. 3. Check that the meter is displaying the available credit in kWh. If a zero balance is displayed, a credit token needs to be purchased and entered into the meter using the keypad. -
Page 8: Display Messages
Display Messages Error Description code No Credit Available: A credit token is Meter not initialised - contact Conlog required to connect the supply Meter not calibrated - contact Conlog To Commission: Press #43# Load will Internal error - contact Conlog connect and tamper will activate. -
Page 9: Product Specifications
Conlog shall not be liable for any consequential loss of whatever nature and howsoever arising including, but not limited to, loss arising from any defect in the product sold which is covered by Conlog’s warranty, or from negligence on the part of Conlog, its directors, employees or agents. Conlog (Pty) Ltd Reg. No.