Figure 3-14
Connect the engineering tool to the serial communication port
(TOOL) of the EN811 module to obtain the information of the
current EN811 module.
Select [Transmission parameter (P)] from [Tool (T)] on the menu bar to
set the transmission parameters.
Register the following and click [OK]. Refer to "Table 3-15
Transmission parameter setting screen"
Transmission method : RS-232C
Port : COM1 (specify the port to use.
Timeout time (s): 5
Ethernet timeout time (s): 4,
Own station setting: Single
IP Address: 172.16.64.1
Unified Controller nv series Ethernet (EN811) Module Operation Manual
3.3 Setting with the engineering tool
Ether LAN connection screen
COM1 in this example)
29