Table of Contents
V-belt case air duct bolt
7 N·m (0.7 kgf·m, 5.2 lb·ft)
V-belt case air filter element cov-
er bolt
7 N·m (0.7 kgf·m, 5.2 lb·ft)
Air filter case bolt
10 N·m (1.0 kgf·m, 7.4 lb·ft)
TIP
To route the rear wheel sensor lead, refer to
"CABLE ROUTING" on page 2-13.
7. Install:
• Air filter case cover
Refer to "AIR FILTER CASE" on page 7-11.
EAS30801
CHECKING THE BRAKE OPERATION
1. Check:
• Brake operation
Brake not working properly → Check the
brake system.
Refer to "FRONT BRAKE" on page 4-38 and
"REAR BRAKE" on page 4-51.
TIP
Drive on the road, operate the front and rear
brakes separately and check to see if the brakes
are operating properly.
EAS30633
CHECKING THE FRONT BRAKE PADS
The following procedure applies to all of the
brake pads.
1. Operate the brake.
2. Check:
• Front brake pad
Wear indicator grooves "a" almost disap-
peared → Replace the brake pads as a set.
Refer to "FRONT BRAKE" on page 4-38.
EAS30634
CHECKING THE REAR BRAKE PADS
The following procedure applies to all of the
brake pads.
a
a
3-11
PERIODIC MAINTENANCE
1. Operate the brake.
2. Check:
• Rear brake pad
Wear indicators "a" almost touch the brake
disc → Replace the brake pads and brake
pad shims as a set.
Refer to "REAR BRAKE" on page 4-51.
a
EAS30632
CHECKING THE BRAKE FLUID LEVEL
1. Stand the vehicle on a level surface.
TIP
• Place the vehicle on the centerstand.
• Make sure the vehicle is upright.
• In order to ensure a correct reading of the
brake fluid level, make sure the top of the brake
fluid reservoir is horizontal.
2. Check:
• Brake fluid level
Below the minimum level mark "a" → Add the
specified brake fluid to the proper level.
Specified brake fluid
DOT 4
A
a
Chapters
Table of Contents
Troubleshooting
