Page 6
The unit leaves the factory set at the CLOSE position. Locating hole Screw hole OPEN position (Mesh end toward back) COOL HIGH MODE TIMER TEMP SLEEP Fan Cycle/Continuous - Cool Locating hole Screw hole CLOSE position (Mesh end toward front) Fan Cycle/Continuous - Cool No function (reserved for future use)
Page 7
Grille On some models On some models Grille...
Page 8
FRONT FRONT Dirty filter—Needs cleaning Clogged filter—Greatly reduces cooling, heating and airflow.
Page 13
Brick veneer Lintel angle (if required) Caulking (on all 4 sides on the outside and inside of the case) Caulking (above and below the flashing) Flashing (drip rail) 1/4 min. extension inside the wall from the trim molding Caulking Plaster line Trim molding (if desired) Room side...