CONTENTS General information ... 11 Installation and safety notices ... 11 Accessories ... 11 Supplied parts ... 12 Switching on/off ... 12 Switching on the signal controller .. 12 Switching off the signal controller .. 12 Settings ... 13 External monitor switch (Fig. 2) ... 13 Monitor connections ...
General information Thank you for choosing a Blaupunkt product. We hope you enjoy using this new piece of equipment. Please read these operating instruc- tions before using the equipment for the first time. The Blaupunkt editors are constantly working on making the operating in- structions clearer and easier to under- stand.
SUPPLIED PARTS Supplied parts The signal controller is supplied with all the parts listed below. Please check that the range of parts supplied with your device is complete. If one of the listed parts is missing, please contact your dealer immediately. Signal controller 7 607 003 551 Connecting cable Screws...
Settings External monitor switch (Fig. 2) Switch position on right: No external monitor connected. Switch position on left: If a Blaupunkt navigation (RGB) monitor is connected via a Y-cable (7 607 001 600). Monitor connections Note: From the FRONT, LEFT, RIGHT...
IR REMOTE CONTROL 1 POWER On/off button for the selected monitor or monitors. 2 NAVI Selects the navigation monitor. 3 VOL • arrow button Increase the volume for the se- lected monitor (not Audio OUT). VOL • arrow button Decrease the volume for the se- lected monitor (not Audio OUT).
Installation Installation and safety notices Before connecting your signal control- ler, please read the following informa- tion carefully. The battery’s negative terminal must be disconnected for the entire time it takes to install and connect this device. When doing so, observe the vehicle manufacturer’s safety notices (airbags, alarm systems, trip computers, immo- bilizers).
INSTALLATION made to the vehicle, please contact a specialist workshop in your area. Note: You cannot display PAL video on the wide vision TV monitor using the RGB input. In this case, the PAL video signal must be connected directly to the AV input of the wide vision TV monitor..
Anschlussbilder • Connection diagrams • Schéma électrique • Schemi di allacciamento • Aansluittekeningen • Anslutningsbilder • Esquemas de conexión • Esquemas de ligação • Tilslutningsskemaer 1 2 V Fig. 1 +12V Ignition Ext-monitor IR DC 12V IN RGB-IN AUDIO-IN +12V Permanent (Batterie, battery) Masse / GND...
Page 11
Fig. 2 Audio in-right Audio in-left Fig. 3 FRONT MONITOR MONITOR DC 12V IN Video in Externer Monitorschalter LEFT RIGHT OVERHEAD MONITOR IVMS 5802 IVMS 6502 IVMR 9002 IVMR 1042 Ext-monitor IR RGB-IN AUDIO-IN IR-Empfänger (Eingang) IR receiver in Audio OUT RGB OUT (right) (left)