Table of Contents
Quick Links
Table of Contents
Related Manuals for GE ZEU676YSB
Summary of Contents for GE ZEU676YSB
- Page 1 ® GE Monogram Installation Instructions 36" Ceramic Cooktop Model ZEU676YSB...
-
Page 2: Table Of Contents
This appliance must be properly grounded. See “Electrical Supply”, page 4. CAUTION WARNING If you have questions concerning the Proper installation is the responsibility of the installation of this product, call the GE installer. Product failure due to improper ® Answer Center Consumer Information installation is not covered under the GE Service at 800.626.2000, 24 hours a day,... -
Page 3: Models Available
Design Information Ceramic Cooktop ZEU676YSB This Monogram cooktop offers a smooth Models Ceramic Cooktop glass surface with bridgeburner to form an Available elongated heating area and is surrounded by a stainless steel trim. Dimensions & Clearances • The underside (recessed) dimensions are: –... -
Page 4: Installation Preparation
Installation Preparation Ceramic Cooktop IMPORTANT: This cooktop requires 50 Amp – Maintain 24" minimum clearance when Advance service. bottom of wood or metal cabinet is pro- Planning • Use this cooktop with any exhaust hood; no tected by not less than 1/4" thick flame- special ventilation is required. -
Page 5: Step 1: Cut The Opening
Installation Preparation Ceramic Cooktop S tep Cut the Opening Caution: Wall coverings, countertops and cabinets should withstand 200°F heat generated *A=30 inches minimum clearance between the top of the cooking surface and the bottom of by the cooktop. an unprotected wood or metal cabinet or A=24 inches minimum when bottom of wood or metal cabinet is protected by not less than 1/4 inch thick flame-retardant millboard covered with not less than no. -
Page 6: Installation
Installation Ceramic Cooktop Step Install Cooktop • Place foam gasket on the underside of the cooktop flange all the way around. • Lower the cooktop into the countertop opening. • Make sure the cooktop is evenly seated and supported. • Insert 2 hold-down brackets in slots on right and left sides of chassis. -
Page 7: Step 3: Connect Electrical
Installation Ceramic Cooktop Step Connect Electrical Verify that power is turned off at the source When connecting to a 3-conductor branch circuit: Connect cooktop flexible power cable to • Connect cooktop red lead to branch circuit junction box: red lead. •... - Page 8 NOTE: While performing installations described in this book, safety glasses or goggles should be worn. To obtain specific information concerning any ® Monogram product or service, call GE Answer Center consumer information service at 800.626.2000—any time, day or night. For Monogram local service in your area, call 1-800-444-1845.