Table of Contents
Positioning and connecting
en
The following are available from
Tip:
specialist dealers/the after-sales
service:
An extension for Aqua-Stop or cold
■
water supply hose (approx. 2.50 m);
order no. WMZ2380, WZ10130,
CZ11350, Z7070X0
A longer supply hose (approx.
■
2.20 m) for standard model
Water inlet
:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Observe the following when connecting
the machine:
Notes
Only operate the washing machine
■
using cold mains water.
Do not connect the machine to the
■
mixer tap of an unpressurised hot-
water boiler.
Do not use a used supply hose. Only
■
use the supply hose supplied with
the machine or one that was
purchased from an authorised
retailer.
Do not bend, squash, modify or cut
■
through the water supply hose
(otherwise its strength is no longer
guaranteed).
Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may be
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow is
at least 8 l/min.
36
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Connection
Connect the water supply hose to
1.
the water tap (¾" = 26.4 mm) and to
the appliance:
– Model: Standard
– Model: AquaSecure
Connect also an external water
Tip:
filter between water supply hose and
tap. The filter filters dirt particles out
of the water.
Water filter must be cleaned regularly
to remove contaminants. This will
prevent blockages. See also ~
separate installation and cleaning
instruction for water filter.
Open the water tap carefully,
2.
checking the leak tightness of the
connection points. The screw
connection is under mains water
pressure.
Table of Contents
