Table of Contents
Speaker System Connections
Connect the SYSTEM to the SYSTEM CONNECTOR at the rear of the Active Subwoofer Speaker, using the
supplied System cable.
Connect the speakers using the supplied speaker cables.
To obtain the best possible surround sound, adjust the speaker parameters (volume, distance, etc.).
Notes:
Be sure to match the speaker cable to the appropriate terminal on the components: + to + and – to –.
If the cables are reversed, the sound will be distorted and will lack base.
If you use front speakers with low maximum input rating, adjust the volume carefully to avoid excessive output
on the speakers.
About Ferrite Core
Be sure to attach the ferrite core to the system
cable. This ferrite core can reduce noises.
How to attach the ferrite core
1. Press the stopper [a] of the ferrite core to open.
2. Wind the system cable once on the ferrite core.
3. Close the ferrite core until it clicks.
Note:
Attach the ferrite core near the unit (Refer to the
fig.3 and comment.).
16
AM
GND
ANTENNA
FM
The length here is short
as much as possible.
Hide quick links:
Table of Contents
