Steps
1. Align the screw holes on the rear-I/O bracket with the screw holes on the display-assembly base.
2. Replace the three screws (M3x5) to secure the rear-I/O bracket to the display-assembly base.
3. Route the power-supply cables through the routing guide on the rear-I/O bracket.
4. Align the screw hole on the power-supply socket with the screw hole on the rear-I/O bracket, and place it in the slot on the rear-I/O
bracket.
5. Replace the screw (M3x5) to secure the power-supply socket to the rear-I/O bracket.
Next steps
1. Install the
bottom
cover.
2. Install the
system-board
3. Install the
back
cover.
4. Install the
cable cover
(optional).
5. Install the stand.
6. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
NOTE:
Your computer's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
shield.
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
61