Table of Contents
9.2.7.
Setting the SD PCB, Heat Sink and FAN Motor
1. Connect the SD FFC to the Connector (CN1401).
2. Fix the SD PCB to the computer using the three
Screws.
3. Set the Heat Sink, Fan Duct and the four Heat Sink
Springs.
4. Fix the FAN Motor to the computer using the two
Screws.
5. Attach the Fan Tape 1 and 2 on the FAN Motor, and fix
the Cable Holder on them.
Screws : DXSB2+6FNL
Screws : DFHE5025XA
Applying Grease on the Heat Sink
1. Apply grease on two points of the Heat Sink.
2. Attach the Pipe Sheet on the Heat Pipe.
Pipe Sheet
Match the end of the Pipe Sheet.
(0 ~ -2mm)
Fold on the center line
and attach it.
Grease is applied.
G751(10mmX10mmXt0.3)
SD PCB
SD FFC
CN1401
Heat Sink
Spring
Fan Dust Sheet
(Attach the Fan Duct Sheet
to the back side.)
5~10mm
Fan Dust Sheet
Heat Sink
Grease is applied.
G751(10mmX10mmXt0.3)
9-14
Cable Holder
Fan Tape2
Fan Tape1
Fan Duct
FAN Motor
Heat Sink
Heat Sink
Spring
0~1mm
0~1mm
0~1mm
0~1mm
Table of Contents
