Controls - GE PV977 Owner’s Manual And Installation Instruction

Island chimney vent hoods
Table of Contents
Available languages

Available languages

Controls

1. MEMORY/OFF:
To set the memory:
A. Press the MEMORY/OFF button
B. Set your desired fan and light settings
C. Press the MEMORY/OFF button again to save
these settings.
With your desired settings in memory, press the
MEMORY/OFF button to restore the fan and light
levels to their saved settings. These settings will
remain in memory until they are changed or loss of
power occurs.
To turn off the hood, press the MEMORY/OFF
button.
2. LIGHT:
Press + or – to increase or decrease light
level to desired setting. There are 2 light levels
(LOW, HIGH) and OFF. If you continue to press the
+ or – buttons, the light will cycle back through the
settings.
NOTE: Please check the lamps to ensure only 20W
lamps (maximum) are installed.
3. FAN:
Press + or – to increase or decrease fan
level to your desired setting. There are 4 fan levels
(LOW, MED, HIGH, BOOST) and OFF. If you
continue to press the + or – buttons, the fan will
cycle back through the settings.
NOTE: There is an audible "beep" each time a
button is pressed. This is normal.
NOTE: The collars around the buttons will
illuminate when pressed. This is normal. The
collars will automatically turn off if the hood is
turned off.
49-2000833 Rev. 0
3
2
HEAT SENSOR:
This hood is equipped with a heat sensor that will turn
on the fan if excessive temperatures are detected (over
return to its normal operation once the heat sensor
NOTE: If the hood is OFF or on LOW fan speed, the
fan will automatically adjust to MED speed. You may
adjust the fan speed to HIGH or BOOST, but you will
not be able to adjust the fan speed to LOW or OFF until
NOTE: The collars around the buttons may not illuminate
if the heat sensor is activated. This is normal.
1
5

Chapters

Table of Contents
loading

Table of Contents