Lubrication System; Air Filter - Husqvarna 555 Workshop Manual
Hide thumbs
Also See for 555:
- Operator's manual (92 pages) ,
- User manual (60 pages) ,
- Workshop manual (59 pages)
Table of Contents
7.12 Lubrication system
7.12.1 To disassemble and assemble the
lubrication system
WARNING: The saw chain can break if the
lubrication is not sufficient.
The lubrication system has an oil pump, a suction hose
with a filter and an oil hose with an integrated filter.
1. Drain the oil from the oil tank. Clean the oil tank.
2. Remove the cylinder cover and the clutch cover.
3. Remove the clutch. Refer to
centrifugal clutch on page 32 .
4. Remove the screw (A) and the guide bar plate (B).
E
D
5. Remove the screws (C) and the pump housing (D).
6. Pull out the oil hose (E) from the crankcase.
7. Remove the worm gear (F).
8. Assemble in the opposite sequence.
34 - Repair instructions
To disassemble the
B
A
F
C
7.12.2 To clean and examine the lubrication
system
1. Clean and examine all parts carefully. Replace
damaged parts. Always use the original spare parts.
2. Use chain oil to lubricate all moving parts.
7.13 Air filter
7.13.1 To remove and install the air filter
1. Remove the cylinder cover.
2. Turn the knob and remove the air filter from the air
filter holder.
3. Install in the opposite sequence.
7.13.2 To clean and examine the air filter
1. Examine the air filter.
2. Clean the air filter if it is dirty. Shake the air filter and
use compressed air to remove dirt particles.
3. Replace the air filter if it is damaged.
1540 - 001 -
Hide quick links:
Table of Contents
Troubleshooting
