Important information | Switching on/off | Settings | Technical data
Installation notes
Important note:
The installation of the monitor requires the
adapter cable 7 620 280 125 (to be obtained
separately).
Important note:
The monitor may only be attached to one of
these holders:
f
Fixed holder for roof mount
(7 620 340 031)
f
Fixed holder for wall mount
(7 620 340 033)
Swivel holder (7 620 340 032)
f
Please carefully observe the installation
instructions of the respective holder.
Note:
Please also observe the information given in
the device drawings at the end of this docu-
ment.
Please observe the following installation notes:
f
Do not exert external force onto the frame and
visible surface of the LCD.
Do not exceed the maximum length of the device's
f
supply cables.
The device's supply cable must provide a minimum
f
cross sectional area of 1.5 mm
f
Observe the minimum bending radius of the
device's supply cables.
Ensure that the device's supply cables are pro-
f
tected against sharp edges.
Mount the device or its holder respectively only to a
f
stiff surface with enough stability for the system.
f
Only use suitable screws and washers for mounting
the device to the holder.
Observe the required thread reach and torque.
f
f
Air convection and ventilation must be ensured. Do
not cover the ventilation holes.
Switching on/off
The device is automatically switched on or off by the
Coach Infotainment system of your Vehicle.
Robert Bosch GmbH
Settings
The monitor provides setting options (via Center
CM-C 19) for:
f
f
f
f
f
Technical data
Power Supply
Current consumption
Diagonal display size
Resolution
Contrast ratio
Luminance
Screen format
Viewing angle
.
2
Backlight
Flash memory
Operating frequency
Network interface
Operating temperature -25 °C to +65 °C
Storage temperature
Dimensions (L x W x H) 537 x 329 x 51 mm
Weight
Certification
Subject to changes!
Brightness
Contrast
Gamma correction
Aspect ratio (3 modes for autoscaling of 16:9 and
4:3 picture sources)
Reset to factory settings
Note:
Please refer to the user manual of the Center
CM-C 19 for information about making settings
for the connected monitor.
24 V (17 V – 36 V)
In operation
5 A
Max. current
< 10 A
Standby current
max. 100 μA
21" ±1.5"
1920 x 1080 pixels
1000 : 1
Min. 250 cd/m2
16:10, 16:9
±80° in all directions
LED
2 Gbits
60 Hz
OABR | 2 ports | speed rate:
100 Mbits/s full duplex
-25 °C to +75 °C
Approx. 3.5 kg
CE, UN ECE R10,
UN ECE R118
7 620 310 073 | 09.2020
en | 3
