Remote Control Operations; Remote Functions - GE 20390 User Manual

"Sync" switch:

" " button

This button controls the light and also

controls the brightness setting. Press and

release the button to turn the light ON or OFF.

Press and hold the button to set the desired

brightness: the light will slowly illuminate to

maximum light output and then stop when

holding the button, then release the button

and hold it again until it reaches minimal

illumination where it will automatically stop

again. The light button has an auto-resume,

it will stay at the same brightness as the

last time it was turned off.

Note :

.

To prevent damage to transmitter, remove the batteries if not used for long periods.

.

Replace batteries as a simultaneous set – always replace the whole set of batteries at one time, taking care not to mix old and new ones, or batteries of

different types.

.

Please contact your local batteries recycling center for proper battery disposal information.

14

Operation Instructions

" O " and " I " dip switch

Medium speed

Low speed

Step 1.

Restore power at circuit breaker and turn the wall switch to the on

position (if using wall switch) to test for proper operation,

Step 2. Open the battery compartment cover, and then install two 1.5-volt

AAA batteries (KK) provided in the remote control bag. Ensure the batteries

are installed correctly with regard to polarity (+ and -).

Step 3. Check " O " and " I " dip switch: For this fan the dip switch should be

in the " O " position as the LED bulb of the fan is not dimmable. Place the

switch in the " I " position to turn the dimming feature on. Important Note:

Dimming feature does not apply to fan or bulb without dimming feature.

Step 4. Close the battery compartment cover and see below diagram for the

function of each button on the transmitter.

Step 5. Select a location to install the transmitter holder, Mount the transmitter

holder using the wood screws provided.

IMPORTANT: If the remote control is not operating correctly, please follow

the steps on page 16, item 5 for syncing the switch. Use the corner of the

battery cover to press the "Sync" switch for syncing function.

Note: This Fan and Remote has a dimming function for the light. You can

control the brightness of the light with the

remote. Please see below for Remote Functions.

Operation indicator

This button turns the fan ON or OFF.

High speed

" "

This button delays the light turning off

for approximately 5 seconds, enabling

you to exit your room before the light

turns completely off.

" " button

on the hand held

button