Bosch SHP88PW55N Operating Instructions Manual page 34

Hide thumbs Also See for SHP88PW55N:
Table of Contents
Available languages

Available languages

en-us Operating the Dishwasher
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
Open the door.
1.
Switch off On/Off switch (.
2.
The LED's go out. The wash cycle
is saved.
To continue the wash cycle,
3.
switch on the On/Off switch (
again.
Close the door.
4.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Cancel a cycle (Reset)
Open the door and press and
1.
hold Start button P for
approximately 3 seconds until the
display reads ‹:‹‚, then close
door again.
Wait about 1 minute while the
2.
dishwasher drains.
Open the door and press the
3.
On/Off button (.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
34
Intensive drying
The final rinse uses a higher
temperature which improves the
drying result. The cycle time may
increase slightly. (Caution if utensils
are delicate!)
This feature has two settings:
š:‹‹ Off
š:‹‚ On
To change the setting:
Open the door.
1.
Press On/Off button (.
2.
Hold down function key # and
3.
press Start button P until the
display 8 indicates •:x (x can
be any number).
Release both buttons.
4.
The indicator of function key #
flashes and the display 8
indicates the factory set value
•:‹...
Press function key # until the
5.
display 8 indicates the factory
set value š:‹‹.
Press function key 3 to switch
6.
the feature on š:‹‚ or off š:‹‹.
Press Start button P to save
7.
setting.
TimeLight
®
(Optical display while the
wash cycle is running)
While wash cycle is running, an
optical display (additional cycle
information) is indicated on the floor
under the appliance door. If the base
panel is pulled forwards or if the
appliance is installed at eye-level with
flush furniture front, the display is not
visible.
Table of Contents
loading

This manual is also suitable for:

Shx88pw55nShv88pw53n

Table of Contents