Location - Stuart Turner MAINSBOOST MB 100CV Installation, Operation & Maintenance Instructions Manual

Hide thumbs Also See for MAINSBOOST MB 100CV:

Table of Contents

3 LOCATION - GENERAL

3.11 Access: For emergencies and maintenance the Mainsboost must

3.12 Protection: The system must be located in a dry position, and

3.13 Incoming mains water pressure: An incoming water pressure of at least 2.0

bar is required and should not exceed 5 bar. (If mains pressure is below 2.0

bar the Mainsboost vessel should be supplemented with a pump unit, contact

Stuart Turner for details).

3.14 Ensure that location of the unit allows adequate space to give reasonable

access to all parts to accommodate service/commissioning.

3.15 Pipework: Pipework should be sized to ensure optimum performance of the

system.

3.16 Direction of flow: See Fig. 3 to identify the suction and discharge

connections.

be easily accessible.

protected from freezing. Avoid environments which have a high

ambient temperature, high humidity or excessive condensation

and salt damage, etc.

- 7 -