Web-Based Switch Configuration; Introduction; Login To Web Manager - D-Link xStack DES-3800 Series User Manual
Layer 3 stackable fast ethernet managed switch
Hide thumbs
Also See for xStack DES-3800 Series:
- Cli manual (326 pages) ,
- User manual (391 pages) ,
- User manual (360 pages)
Table of Contents
Web-based Switch Configuration
Introduction
Login To Web manager
Web-Based User Interface
Basic Setup
Reboot
Basic Switch Setup
Network Management
Switch Utilities
Network Monitoring
IGMP Snooping Status
Introduction
All software functions of the Switch can be managed, configured and monitored via the embedded
web-based (HTML) interface. The Switch can be managed from remote stations anywhere on the
network through a standard browser such as Opera, Netscape Navigator/Communicator, or Microsoft
Internet Explorer. The browser acts as a universal access tool and can communicate directly with the
Switch using the HTTP protocol.
The Web-based management module and the Console program (and Telnet) are different ways to
access the same internal switching software and configure it. Thus, all settings encountered in web-
based management are the same as those found in the console program.
Login to Web Manager
To begin managing your Switch, simply run the browser you have installed on your computer and
point it to the IP address you have defined for the device. The URL in the address bar should read
something like: http://123.123.123.123, where the numbers 123 represent the IP address of the Switch.
This opens the management module's user authentication window, as seen below.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
NOTE: The Factory default IP address for the Switch is
10.90.90.90.
Section 5
26
Table of Contents
