Error Codes On Front Display Panel; Troubleshooting Chart - Kinetico S Series Owner's Manual

First restart attempt - One (1) minute after E02 error code initiates, Second restart attempt - Two (2) minutes after E02

error code initiates, Third restart attempt - Five (5) minutes after E02 error code initiates.

The front panel display is used to communicate system diagnostic information. The following diagnostic codes may be

displayed.

E02 - Low inlet water pressure

Problem

1.

No water production.

(Error code E02 may be

displayed)

2. Low water production.

3. High TDS.

4. Water flows to the drain

when tank is full.

System is off with tank full and

there is pressure on the system

pressure gauge.

5. System does not stop when

tank is full.

6. System starts but pump does

not start.

7. Excessive drain water flow.

8. Low system pressure.

9. Membrane or filter change

indicated.

(Error code E05 or Error Code E06)

S-Series Technical Manual

E05 - Filter change indicated

Possible Cause

A. Low feed pressure at inlet.

High pressure drop.

Clogged prefilters.

B.

If feed water pressure at the inlet

is higher than 80 psi, the pressure

transducer may be damaged.

C. Pump thermal overload has

been actuated.

A. Clogged prefilter.

B.

Fouled membrane.

C. Pump failure.

D. EverClean Rinse solenoid valve

fails in the open position.

Membrane failure due to age or

chlorine damage.

A. Inlet solenoid valve is not closing.

B. EverClean Rinse solenoid valve

fails in the open position.

A. Damaged product water

transducer.

B. Damaged controller.

C. Damaged pressure switch

(atmospheric tanks only).

System is in PUMP OFF mode.

A. Flow restrictor failure.

B. Damaged membranes.

C. EverClean Rinse solenoid valve

fails in the open position.

Pump failing.

Display will indicate when mem-

brane or filter change is overdue.

17

E06 - Membrane change indicated

A. Check prefiltration. Make changes to

reduce pressure drop. Replace filters,

if needed.

B. Replace low pressure transducer.

C. Wait 30 minutes. Reset overload

relay in the power box. If the relay

breaks the power to the pump again,

repair the pump/motor.

A. Replace prefilters.

B. Analyze pretreatment. Replace the

membrane.

C. Replace pump.

D. Replace the EverClean Rinse

solenoid valve.

Check chlorine levels. Adjust pretreatment.

A. Clean or replace solenoid valve.

B. Replace the EverClean Rinse

solenoid valve.

A. Replace transducer.

B. Replace the NBX controller board.

C. Replace pressure switch.

Press OFF button to turn the system off.

Press the ON button until the button

lights up, release the button. System

should return to normal operation.

A. Replace flow restrictor.

B. Analyze pretreatment. Replace the

membrane.

C. Replace the EverClean Rinse

solenoid valve.

Repair or replace the pump.

Perform filter or membrane maintenance

as indicated. Follow procedure on pages

15-17 to reset the maintenance indicators.

Solution