Table of Contents
Instrument and control functions
To use the power outlet
1. Turn the vehicle power off.
2. Open the front storage compart-
ment lid. (See page 7-18.)
3. Remove the power outlet cap.
4. Turn the accessory off.
5. Insert the accessory plug into the
power outlet.
6. Turn the vehicle power on and
start the engine.
7. Turn the accessory on.
TIP
When finished riding, turn off the ac-
7
cessory and disconnect it from the
power outlet, and then install the cap.
1
1. Auxiliary DC jack
WARNING
To prevent electrical shock or short-
circuiting, install the cap when the
power outlet is not in use.
7-20
EWAN0050
Sidestand
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
EAU15306
EWA10242
Hide quick links:
Table of Contents
Troubleshooting
