Pioneer CM Series Installation And Instruction Manual
Surface mount speaker
Hide thumbs
Also See for CM Series:
- Installation and operating instructions manual (36 pages) ,
- Installation and instruction manual (8 pages)
Related Manuals for Pioneer CM Series
Summary of Contents for Pioneer CM Series
- Page 1 Installation and Instruction Manual CM Series Surface mount speaker CM - S54T / CM - S56T / CM - S58T http://pioneerproaudio.com For installation and other support information, visit the above site.
-
Page 2: Installation
Introduction Thank you for purchasing this product. Be sure to read the "Read Before Use" before using this product. Also, read the installation and user's manual from the support site that can be viewed from the URL or QR code given here. You may require the installation and user's manual in future, so keep them carefully at a safe location. - Page 3 • Locations where salt damage or corrosive gases may occur. Usage Methods • Locations where clumps of accumulated snow may fall. There is a risk of deformation or discoloration of the enclosure and Do not use the loudspeaker in the following states. failure of the loudspeaker, which may result in fire or the loudspeaker • Do not exceed the permissible input.
-
Page 4: Checking The Accessories
Checking the Accessories Installation and Connection • U-bracket, 1 × 2 sets WARNING *Attached on the main unit during shipment. • Make sure that the wall or ceiling where you are installing the speaker is strong enough to support it. • Use screws that are appropriate for supporting the weight of the loudspeaker. - Page 5 Loop through connection Attaching the Fall Prevention Wire to With this connection method, it is easier to identify which speaker the Speaker is experiencing trouble. If the Euroblock connector is disconnected from a speaker, subsequent speakers will no longer operate. Connect the cable from the previous speaker to the IN "+"...
- Page 6 2 Insert the Euroblock connector 1 into the rear socket, Attaching the U-Bracket to the fit the speaker cable into the groove 3 from above the sealing cushion 2 , and attach the terminal cover 4 Loudspeaker using four M4 x 12 truss head tapping screws 5 . Fastening torque: 2 to 3 N∙m 1 Set the loudspeaker inside the U-bracket 1 , tighten the U-bracket knob screw 2 from the top and bottom to...
- Page 7 Installing the Loudspeaker Without a U-Bracket 1 If you install the loudspeaker on a wall or ceiling using the two M6 nuts on the back without using the supplied U-bracket, remove the U-bracket from the loudspeaker according to "Attaching the U-Bracket to a Wall or Ceiling"...
-
Page 8: Specifications
Other Specifications CM-S54T CM-S56T CM-S58T Loudspeaker Type Two-way passive, reflex-loaded Two-way passive, reflex-loaded Two-way passive, reflex-loaded Frequency response 95 Hz – 20 kHz 80 Hz – 20 kHz 53 Hz – 20 kHz (- 10 dB, Typical) Sensitivity (1 W / 1 m) 87 dB 88 dB 91 dB... - Page 9 Dimensional Drawings (Unit : mm (inches)) CM-S58T CM-S56T CM-S54T...
- Page 10 © 2020 AlphaTheta Corporation. All rights reserved. 6F, Yokohama i-Mark Place, 4-4-5 Minatomirai, Nishi-ku, Yokohama, Kanagawa 220-0012 JAPAN 〒220-0012 神奈川県横浜市西区みな とみ らい4丁目4番5号 横浜アイ マークプレイ ス6階 6F, Й а а i-Mark Place, 4-4-5 М а а , Н - , Й а а, Ка а а а 220-0012 ЯПОНИЯ Artemis Building, Odyssey Business Park, West End Road, South Ruislip, Middlesex, HA4 6QE, U.K.