Table of Contents
The 'clamp' mounting style (i.e. using end clamps and mid clamps along the module frame for
securing modules to the racking system) may also be utilized. It is recommended that the clamp be
placed within +/- 1" (25 mm) of the centerline of the factory mounting hole.
CAUTION:
Contact Bosch Solar Energy if only the short frame edges are to be used for anchoring the module.
This type of mounting method typically requires additional analysis by Bosch Solar Energy. Failure to
do so may invalidate the warranty.
7. ELECTRICAL INTERCONNECTIONS
A. Module To Module Interconnection
Bosch Solar Energy modules have been designed to be easily interconnected. Each module
comes with one positive (+) cable with a plug on one end and one negative (-) cable with a
receptacle on one end. Both wires are connected inside of the junction box (diode housing).
Copyright Bosch Solar Energy Corp., version 1.0
Figure 6A: Example Mounting Method
Figure 6B: Illustration of Mounting Hardware
Page 12 of 19
Table of Contents
