Replacing The Lamp; Closing The Door - Electrolux SANTO 76308 KA User Manual

Problem

Water flows on the rear

plate of the refrigerator.

Water flows into the re-

frigerator.

Temperature cannot be

set .

The temperature in the

appliance is too low/high.

The temperature in the

refrigerator is too high.

1. Switch off the appliance.

2. Press on the rear hook and at the same

time slide the cover in the direction of

the arrow.

3. Replace the lamp with one of the same

power and specifically designed for

household appliances. (the maximum

power is shown on the lamp cover).

4. Install the lamp cover by sliding it into

its original position.

5. Switch on the appliance.

6. Open the door. Make sure that the light

comes on.

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "Installation".

3. If necessary, replace the defective door gaskets. Contact the Service Center.

Possible cause

During the automatic defrost-

ing process, frost defrosts on

the rear plate.

The water outlet is clogged.

Products prevent that water

flows into the water collector.

TURBO COOLMATIC function

switched on.

The temperature regulator is

not set correctly.

The door is not closed correctly. Refer to "Closing the door".

The product temperature is too

high.

Many products are stored at

the same time.

There is no cold air circulation

in the appliance.

What to do if...

Solution

This is correct.

Clean the water outlet.

Make sure that products do not

touch the rear plate.

Switch off TURBO COOLMATIC

manually, or wait to set the tem-

perature until the function has

reset automatically. Refer to

"TURBO COOLMATIC function"..

Set a higher/lower temperature.

Let the product temperature de-

crease to room temperature be-

fore storage.

Store less products at the same

time.

Make sure that there is cold air

circulation in the appliance.

15