Quick Links
Before calling service
Automatic Ice Maker does not work
(Only for model RFG293)
• Allow your refrigerator to operate and
cool down for 24 hours (1 full day) be-
9
fore the ice maker starts producing ice.
• If
ICE OFF
is lit, the ice maker will not make ice.
• To activate the ice maker, press the
ICE OFF
but-
ton on the control panel so it is no longer lit.
Slow Ice cube freezing
(Only for model RFG293)
• Freezer temperature may not be enough: Set it to
-2°F or lower.
Small or bubbled ice cubes
(Only for model RFG293)
• If the water fi lter is clogged, small or bubbled ice
cubes may be produced.
• Replace the water fi lter cartridge with a new one.
Water fi lter replacement
(Only for model RFG293)
• Turn the water fi lter 90°counter-clockwise and pull it.
Then insert the new water fi lter and turn it clockwise,
until the locked symbol be lined up with the indica-
tor line.
1
2
3
4
Refrigerator or freezer Compartments
are warm
• Allow your refrigerator to operate and cool down
12
for 24 hours (1 full day) to reach to the set tem-
3
perature.
6
• Also, when you put room temperature or warmer
food into your refrigerator, it may need an addi-
tional 24 hours for the fridge to reach the set tem-
perature.
Moisture forms on outside/inside of
refrigerator
• Wipe off the condensation with a dry towel (This
may occur during hot and humid seasons.)
• If the condensation occurs on the doors, turn off
the Energy Saving function.
• If you open the doors frequently or for too long, it
may cause moisture inside the fridge.
Noise Clicks, Pops, Cracks, Snaps
• These noises may be heard occasionally inside
the refrigerator. This is normal. This sound occurs
when various items contract or expand while tem-
peratures are changing; especially during defrost-
ing. This may also occur when electronic devices
including the ice maker are operating.
Food stored in refrigerator is frozen
• If food with too much moisture is stored near the
cooling vents, it may get frozen. Be sure to keep
moist food away from the cooling vents.
Moving and Installing
• When installing, servicing or cleaning behind the
refrigerator, be sure of the following:
• To protect your fl oor's fi nish when moving the
refrigerator, cut a large section of the cardboard
carton and place under the refrigerator where you
are working.
• Pull the unit straight out and push back in straight
after fi nishing.
Display
• If you have the model RFG293, the fi gure may dif-
fer slightly from your refrigerator.
For details, refer to the user manual
"Using the
control panel"
• Recommended Temp Settings : -2°F for freezer and
38°F for refrigerator.
• Ice off : Press the
"Ice Off"
button to turn the ice
making function off.
Cooling Off mode
• Cooling Off (Show Room) mode : If the Display
shows the
"0F 0F"
code, it means that the Cool-
ing Off function is activated and the refrigerator
is not cooling. To cancel this mode, press the
Power Freeze
and
Freezer
buttons at the same
time for 3 seconds until a "Ding-dong" sound is
heard and the unit will now cool.
• Filter indicator (only for RFG293) : The fi lter indi-
cator will be red when you have used your water
fi lter for 300 gallons or 6 months. After replac-
ing the fi lter, reset the indicator by holding the
"Fridge"
"Power Cool"
and
button for 3 sec-
onds. (It will be blue)
Leveling & Door Alignment
• Remove the Cover Leg by unscrewing and pull-
ing it out. Then insert a fl at-blade(-) screwdriver
into slot on the control lever, turn it clockwise or
counter-clockwise to level the door.
Cover Leg
Control Lever
Screwdriver
• Open the freezer drawer to gain an access to the
adjustable hinge pin. Next, adjust the refrigerator
door using the provided 0.16 inch wrench.
RAISE
• If you need to add more height to the door, insert
the provided snap rings.
DA99-02015A REV(0.1)
ENGLISH
