Table of Contents
6. Push the memory module into the slot at a slight angle until the connectors are
fully engaged (Figure 21).
7. Push down on the edge of the memory module until the module snaps into
place.
Figure 21. Installing a Memory Module
8. Align the memory module compartment door with the compartment and push
the door down until it snaps into place.
9. Reinstall the screw you removed in step 2.
10. Turn on the computer and perform a complete POST to check the memory
integrity.
Hard Drives
You can order optional hard drives for your system. A hard drive can be installed
in the hard-drive compartment to replace your existing hard drive see "Installing a
Hard Drive" on page 31 for information on installing a new drive in the hard-drive
compartment. Or you can order a hard drive that fits in the Flex-Bay, in this case,
you should purchase the drive pack to fit in the Flex-Bay.
To install and use the 2nd HDD in the Flex-Bay, you must set the switch on a
device to set it as slave type of IDE bus. Set switch 1 to ON and switch 2 to ON.
See "Using the Flex-Bay" on page 23 for information on installing a device in the
Flex-Bay.
88 Using Options
Table of Contents
