Table of Contents
Available languages
Available languages
CAUTION! Make sure that when
you close the door, the laundry
does not catch between the
appliance door and the rubber
seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and options for the
type of load.
The display shows the programme duration.
The drying time you see is related to
the load of 5 kg for cotton and jeans
programmes. For the other
programmes the drying time is related
to the recommended loads. The drying
time of the cotton and jeans
programmes with the load more than 5
kg is longer.
4. Press the Start/Pauze (Start/Pause) touchpad.
The programme starts.
STARTING THE PROGRAMME WITH DELAY
START
1. Set the correct programme and options for the
type of load.
2. Press the delay start button again and again
until the display shows the delay time you want
to set.
You can delay the start of a
programme from a minimum of 60
minutes to a maximum of 20
hours.
3. Press the Start/Pauze (Start/Pause) touchpad.
The display shows the countdown of the delay
start.
When the countdown is completed, the programme
starts.
CHANGE A PROGRAMME
1. Press the on/off button to deactivate appliance
HINTS AND TIPS
PREPARING THE LAUNDRY
•
Close the zippers.
•
Close the fasteners of duvet covers.
•
Do not dry ties or ribbons loose (e.g. apron
ribbons). Tie them before you start a
programme.
•
Remove all items from pockets.
•
If an item has an internal layer made of cotton,
turn it inside out. Make sure that the cotton layer
is always outward facing.
2. Press the on/off button to activate the
appliance.
3. Set the programme.
STAND-BY FUNCTION
To decrease the energy consumption, this function
automatically deactivates the appliance:
•
After 5 minutes if you do not start the
programme.
•
After 5 minutes from the end of the programme.
AT THE END OF THE PROGRAMME
When the programme is completed:
•
An intermittent acoustic signal operates.
•
The indicator
flashes.
•
The indicators
Condenseur (Condenser) comes on.
•
The Start/Pauze (Start/Pause) indicator is on.
The appliance continues to operate with the crease
guard phase for approximately other 30 minutes.
The crease guard phase removes creases from
your laundry.
You can remove the laundry before the crease
guard phase is completed. We recommend, for
better results, that you remove the laundry when the
phase is almost completed or completed.
When the crease guard phase is completed:
•
The indicator
is on but does not flash.
•
The indicators
Condenseur (Condenser) comes on.
•
Start/Pauze (Start/Pause) indicator goes off.
1. Press the on/off button to deactivate the
appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter and empty the
water container when a programme is
completed.
•
We recommend that you set a correct
programme suitable for the type of fabrics that
are in the appliance.
•
Do not put dark colours together with light
colours. Dark colours can bleed.
•
Use a suitable programme for cotton, jersey and
knitwear to prevent shrinkage.
•
Make sure that the load size is not more than
the maximum stated the programme table.
Bac plein (Tank) and
Bac plein (Tank) and
11
Table of Contents
