DVD MULTI Drive Pack DVD MULTIドライブパック CF-VDM291 FJ0304-1124 DFQX5443ZB Printed in Japan ENGLISH OPERATING INSTRUCTIONS Introduction ..........4 Usage Precautions ........5 Using the Drive .......... 6 Troubleshooting ........10 Specifications.......... 11 DEUTSCH BEDIENUNGSANLEITUNG Einführung ..........12 Vorsichtsmaßnahmen zum Gebrauch ... 13 Gebrauch des Laufwerks .......
Page 2
CAUTION! THIS PRODUCT UTILIZES A LASER. USE OF CONTROLS, ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL WARNUNG! DIESES PROUKT ERZEUGT LASERSTAHLUNG.
Page 3
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the Panasonic Service Center or an experienced radio/TV technician for help. Warning To assure continued compliance, use only shielded interface cables when connecting to a computer or peripheral.
Introduction Thank you for purchasing the DVD MULTI Drive Pack for the Panasonic CF-29 notebook computer series. This drive connects to the computer through the Multimedia Pocket. Store this manual in a safe place after reading it. DVD MULTI Drive Pack* ...
Usage Precautions Do not place items other than discs on the tray. Do not leave the tray in the open position or touch the lens. Under some conditions, dust may build up on the lens, or on a disc. This may result in a read or write malfunction.
Using the Drive Installing/Removing a Device Refer to “Multimedia Pocket” in the Reference Manual included with your computer for details on how to install and remove the drive. Preparations Windows XP Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager] - [IDE ATA/ ATAPI controllers] - [Secondary IDE Channel] - [Advanced Settings] - [Device 0].
Page 7
Setting a Disc Power on your computer. Label side up Open the disc tray. Press the eject button and slowly pull out the tray. NOTE Before using the drive for the first time, re- move the protective sheet from the lens area. The protective sheet inside the drive delays the opening of the drive by about ten sec- onds.
Page 8
Using the Drive Information To play DVD-Video or MPEG2 files, install the DVD playback software (included). For information on how to install the software, refer to the instructions of the software. “WinDVD ” Booklet) If the PC Card does not work, there may be no interrupt request (IRQ) line available. Deactivate unnecessary equipment using in the Setup Utility.
Page 9
When writing to discs Using the CD-ROM of the writer software (included), install the application software on your computer. For information on how to install the software, refer to the included manual of the writer software. ( “DVD Multi Driver/B’s Recorder/B’s CLiP” Booklet) Be sure to use discs conforming to the proper write speeds.
Troubleshooting The computer does not recognize Check the settings by following the instructions in the drive “Preparations” ( page 6). Is the drive properly mounted in the multimedia pocket? Restart the computer. The Multimedia pocket device Is the disc loaded on the tray correctly? status indicator does not light Cannot play disc or read data...
Einführung Wir freuen uns, dass Sie sich für das DVD MULTI-Laufwerk-Pack für Ihr Panasonic-Notebook CF-29 entschieden haben. Dieses Laufwerk wird über das Multimedia Pocket an das Notebook angeschlossen. Sie sollten diese Bedienungsanleitung an einer sicheren Stelle verwahren. DVD MULTI-Laufwerk-Pack* ..
Vorsichtsmaßnahmen zum Gebrauch Legen Sie nur Discs in das Laufwerkfach ein. Lassen Sie das Disc-Fach nicht geöffnet, und berühren Sie das Objektiv nicht. Unter gewissen Bedingungen kann sich Staub auf dem Objektiv oder auf einer Disc absetzen. Daraus können Lese- oder Schreibfehler resultieren. Achten Sie darauf, das geöffnete Fach nicht zu stark zu belasten, es könnte dabei beschädigt werden.
Gebrauch des Laufwerks Installieren/Entfernen eines Gerätes Hinweise zum Installieren/Entfernen des Laufwerks finden Sie unter „Multimedia Pocket“ im „Reference Manual“, das mit Ihrem Computer mitgeliefert wird. Vorbereitungen Windows XP Vergewissern Sie sich, dass [Übertragungsmodus] unter [Start] - [Systemsteuerung] - [Leistung und Wartung] - [System] - [Hardware] - [Geräte-Manager] - [IDE ATA/ATAPI- Controller] - [Sekundärer IDE-Kanal] - [Erweiterte Einstellungen] - [Gerät 0] auf [DMA, wenn verfügbar] eingestellt ist.
Page 15
Einlegen einer Disc Schalten Sie das Notebook ein. Etikettseite nach Öffnen Sie das Laufwerkfach. oben Drücken Sie die Auswurftaste und ziehen Sie das Laufwerk vorsichtig heraus. HINWEIS Achten Sie vor der erstmaligen Inbetriebnahme des Laufwerks darauf, die Schutzfolie von der Abtastoptik zu entfernen.
Page 16
Gebrauch des Laufwerks Informationen Um DVD Video-Discs oder MPEG2-Dateien abzuspielen, installieren Sie die DVD- Wiedergabe-Software (im Lieferumfang). Informationen zur Installation der Software finden Sie in deren Bedienungsanleitung. ( Broschüre für „WinDVD™“) Wenn die Karte nicht funktioniert, steht möglicherweise keine Unterbrechungs- anforderungsleitung zur Verfügung.
Page 17
HINWEIS [Bestätigung der Region] wird auch angezeigt, wenn einen DVD-Video-Disc mit einem bestimmten Regionalcode in ein Laufwerk eingelegt wird, für das bereits ein anderer Regionalcode eingestellt wurde. Beim Schreiben Discs Verwenden Sie die CD-ROM der Schreib-Software (im Lieferumfang), um die Anwendungs-Software auf Ihrem Notebook zu installieren.
Störungsbehebung Das Notebook erkennt das Laufwerk Überprüfen Sie die Einstellungen anhand der nicht Anweisungen im Abschnitt „Vorbereitungen“. Seite 14) Ist das Laufwerk einwandfrei in das Multime- dia-Pocket eingesetzt? Führen Sie einen Neustart des Computers durch. Die Status-Anzeige des Geräts Ist die Disc korrekt in das Laufwerkfach „Multimedia Pocket“...
Introduction Merci d’avoir choisi le Lecteur DVD MULTI pour l’ordinateur portable Panasonic CF-29. Le lecteur se connecte à l’ordinateur par l’intermédiaire du Multimedia Pocket. Conservez précieusement ce manuel après l’avoir lu. Lecteur DVD MULTI* ..... Mode d’emploi ......DVD Multi Drive Utility Disc* Brochure “DVD Multi Driver/...
Précautions d’utilisation Ne placez pas d’objets autres que des disques dans le tiroir. Évitez de laisser le plateau en position ouverte et de toucher la lentille. Dans certains conditions, de la poussière peut s’accumuler sur la lentille ou sur un disque. Cela risque d’entraîner des problèmes de lecture ou d’écriture.
Utilisation du lecteur Installation/Retrait d’un périphérique Reportez-vous à “Multimedia Pocket” dans le “Reference Manual” fourni avec votre ordinateur pour les détails d’installation et de retrait du lecteur. Préparatifs Windows XP Vérifiez que [Mode de transfert] est réglé sur [DMA si disponible] dans [Démarrer] - [Panneau de configuration] - [Performance et entretien] - [Système] - [Matériel] - [Gestionnaire de périphériques] - [Contrôleurs ATA/ATAPI IDE] - [Canal IDE secondaire] - [Paramètres avancés] - [Périphérique 0].
Page 23
Mise en place d’un disque Allumez l’ordinateur. Face de l’étiquette vers le haut Ouvrez le tiroir de disque. Appuyez sur le bouton d’éjection puis tirez lentement le tiroir. REMARQUE Avant d’utiliser le lecteur pour la première fois, retirez la feuille de protection de la zone de la lentille.
Page 24
Utilisation du lecteur Informations Pour lire un DVD-Vidéo ou des fichiers MPEG2, installez le logiciel de lecture de DVD (fourni). Pour plus d’informations sur la manière d’installer le logiciel, reportez-vous au manuel du logiciel. ( Brochure “WinDVD™”) Si la carte PC ne fonctionne pas, il se peut qu’il n’y ait pas d’IRQ (interrupt request) disponible.
Page 25
REMARQUE [Confirmer la zone] apparaît également lorsqu’un DVD-Vidéo dont le code diffère de celui actuellement spécifié sur le lecteur y est inséré. Pour écrire sur des disques Utilisez le CD-ROM du logiciel scripteur (fourni) pour installer le logiciel d’application sur votre ordinateur. Pour plus d’informations sur la manière d’installer le logiciel, reportez- vous au manuel du logiciel scripteur fourni.
Dépannage L’ordinateur n’identifie pas le Vérifiez les réglages en suivant les instructions de la lecteur section “Préparatifs”. ( page 22) Le lecteur est-il correct-ement monté dans le Multi- media Pocket? Redémarrez l’ordinateur. Le témoin d’état de l’appareil Le disque est-il inséré correctement dans le tiroir de Multimedia Pocket disque? s’allume pas...