Used Batteries; Checking The Battery Charge Level; Operation; Use Of Vehicle Adapter - Parkside PHSSA 12-Li A1 Translation Of The Original Instructions

Cordless impact wrench
Table of Contents
Available languages
  • EN

Available languages

  • ENGLISH, page 18
GB
IE
Overview of the LED indicators on
the charger (10):
Green LED (12) lights up
without battery inserted:
Charger ready.
Green LED (12) lights up:
Battery such alleged
charged.
Red LED (13) lights up:
Battery charging.

Used batteries

If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Cleaning and Main-
tenance").
Checking the battery charge
level
The battery's (
cated by the charge state indicator (
The LEDs indicate the battery's charge
level, when the device is in operation.
Press and hold the power button (
red-yellow-green => Battery fully charged
red and yellow
=> Battery half charged
red
=> Battery needs
26
5) charge level is indi-
to be charged

Operation

Use of vehicle adapter

Instead of the battery (5) you can also con-
nect the vehicle adapter (15) to the tool.
1. Insert the vehicle connection plug
(
16) into the 12 V cigarette lighter
socket of your car. The red LED will il-
luminate.
2. Slide the vehicle adapter (15) along
the guide rail into the tool. You will
hear it click into place.
3. To remove the vehicle adapter (15)
from the tool, press the release catch
(15a) on the vehicle adapter and pull
the vehicle adapter out.
The tool continues to draw power
when idle. Ensure that the vehicle
connection plug is not inserted if
you are not using the tool at that
time, to avoid draining the car's
battery.
Set the direction of
rotation
You can select the direction of rotation
with the direction switch (clockwise and
anticlockwise direction).
3).
1. Wait for the device to shut-down.
2. Clockwise direction:
Press direction switch (2) to the
7).
right.
3. Anticlockwise direction:
Press direction switch (2) to the
left.
The direction changed may only be
performed in standstill mode.
Table of Contents
loading

This manual is also suitable for:

298550100244178

Table of Contents