Safety Notes; Laws And Directives - Siemens SITRANS MAG 1100 Operating Instructions Manual

2.1

General requirements

Instrument safety standards

CE marked equipment

www.eltra-trade.com

CAUTION

Correct, reliable operation of the product requires proper transport, storage, positioning and

assembly as well as careful operation and maintenance.

Only qualified personnel should install or operate this instrument.

Note

Alterations to the product, including opening or improper modifications of the product are not

permitted.

If this requirement is not observed, the CE mark and the manufacturer's warranty will expire.

Installation of the equipment must comply with national regulations. For example EN 60079-14

for the European Community.

The device has been tested at the factory, based on the safety requirements. In order to

maintain this condition over the expected life of the device the requirements described in these

Operating Instructions must be observed.

NOTICE

Material compatibility

Siemens Flow Instruments can provide assistance with the selection of wetted sensor parts.

However, the full responsibility for the selection rests with the customer and Siemens Flow

Instruments can take no responsibility for any failure due to material incompatibility.

The CE-mark symbolizes the compliance of the device with the following directives:

● EMC-directive 89/336/EWG

● Low voltage directive 73/23/EWG

2

9

+421 552 601 099