Table of Contents
7. Operation Modes (Control or test) ATyS D20
It is possible to start test sequences or to electrically control the changeover switch from the ATyS D20 keypad.
7.1. Browsing
>
Enter Control or Test modes
• Step 1: Press the "mode" push button until Control or Test led is blinking
• Step 2: Press "validate"; the Control or Test LED then becomes fixed
CONTROL MODE
Access code is displayed
TEST
It is possible to test the LEDs and LCD without entering any code by pressing
Test on load or test off load access codes are displayed after pressing
Press "validate" .
7.2. Operation Modes (Control or test)
>
Exit control or test modes
Press "ESC" push button
Return to any active mode (Automatic or Manual) depends on information from the master ATyS device .
>
Use of Control or Test modes
To run a test, press buttons
To electrically switch positions, press buttons
18
EN
MODE
Enter the access code (0000) using the "left", "right", "up" and "down"
buttons
and
or
,
and
.
ATYS D10 / D20 - 542359B - SOCOMEC
Hide quick links:
Table of Contents
