Reattaching The Hinge Arms; Opening The Computer Cover - Dell Dimension 4200 Manual

Hide thumbs Also See for Dimension 4200:
Table of Contents

Reattaching the Hinge Arms

1.
 Shut down the
computer.
2.  Remove the front door, if attached.
The front door snaps off of the two hinge arms.
3.  Lift both hinge arms to the horizontal position. Then pull the arms toward you until they snap into place.
NOTICE:
Using excessive force to pull the hinge arms into place may damage the arms or the front panel.
If the hinge arms do not snap back into place on the first attempt, slightly reposition the arms and try again.
 
4.  After the hinge arms clip into place, lower and raise the arms two or three times to align them.
5.  Reattach the front door as described in

Opening the Computer Cover

CAUTION:
Before you begin any of the procedures in this section, see
1.
 Shut down the
computer.
2.  Turn off any attached devices and disconnect them from their electrical outlets.
"Reattaching the Front
Door."
"Safety
Instructions."
Table of Contents
loading

Table of Contents