Scope Of Delivery; Installation Location - Bosch KGN Series Instructions For Use Manual

Hide thumbs Also See for KGN Series:
Table of Contents
Dos
Please visit our website to find out
more details regarding e-waste
disposal:
https://www.bosch-home.in/
metapages/e-waste-management
Keep the product in isolated area,
after it becomes non-functional/
unrepairable so as to prevent its
accidental breakage.
Consult the authorized service center
as to whether the Electronic
Equipment can be repaired or not,
before discarding.
Consult the retailer about appliance
take back schemes.
Don'ts
The product should not be opened by
the user himself/herself, but only by
authorized service personnel.
The product is not meant for resale to
any unauthorized agencies/scrap
dealers/kabariwalah.
Do not dispose of the discarded
Electronic Equipment in household
bins or Municipal bins.
Do not dump the discarded Electronic
Equipment in the open or in any land
fill site, as this will result in
contamination of the soil and the
ground water.
Do not keep any replaced spare
part(s) from the product in exposed
area.

Scope of delivery

After unpacking all parts, check for any
damage in transit.
If you have any complaints, please
contact the dealer from whom you
purchased the appliance or our
customer service.
The delivery consists of the following
parts:
Free-standing appliance
Interior fittings (depending on model)
Bag containing installation materials
Operating instructions
Installation manual
Customer service booklet
Warranty enclosure
Information on the energy
consumption and noises

Installation location

A dry, well ventilated room is suitable as
an installation location. The installation
location should not be exposed to direct
sunlight and not placed near a heat
source, e.g. a cooker, radiator, etc. If
installation next to a heat source is
unavoidable, use a suitable insulating
plate or observe the following minimum
distances from the heat source:
3 cm to electric or gas cookers.
30 cm to an oil or coal-fired cooker.
The floor of the installation location must
not give way; if required, reinforce floor. If
the floor is uneven, compensate with
supports.
en
7
Table of Contents
loading

Table of Contents