Table of Contents
Installation and operating manual
Press the button 1x
Press the button 1x
Press and hold the button for 3
seconds; the service LED flashes
briefly 3x
* Purpose of function:
Service B might be carried out at the same time as service A, even if service B is not yet due. In this case, service
messages that have not yet been activated must be acknowledged in order to set the operating hours counter to
"0".
** Note:
Upon a start-up and after acknowledging or resetting an active/not active service in service mode, the adsorber
LEDs are only lit permanently after 1 hour has elapsed, which means that acknowledging is only possible by exiting
the service mode and calling it up again.
NOTE
Exceeding service intervals A and B
As the time intervals between service A and service B might overlap, acknowledging service
A might result in an acknowledgement of service B.
20
Service B is indicated; LEDs are
continuously lit, as service B is not
yet active (time to service has not yet
elapsed).
The adsorber LEDs are off.
Indication only available again after 1
hour.
DRYPOINT
It is possible to reset a not yet active
service message*
Go to next service message by
pressing the button briefly 1x
or wait for 5 seconds until service
mode is terminated automatically
AC 410 – 495 | DRYPOINT
®
EN
AC 410 – 495 MS
®
- Quick Links:
- Technical Data
Hide quick links:
Table of Contents
Troubleshooting
