Table of Contents
Table of Contents
Related Manuals for Ssl DDML28B
Summary of Contents for Ssl DDML28B
-
Page 2: Table Of Contents
CONTENTS Precautions........................1 Precautions & Warnings....................1 Lithium Battery Cell Warnings..................1 Drivers and Connections.....................1 Other Warnings......................1 Installation........................2 Installation Opening....................2 To Install the Car Radio....................2 Electrical Connections....................3 Control Panel Button Locations..................3-4 General Operation......................5 Turn Unit On/Off......................5 Adjust Volume (VOL)....................5 Adjust Menu Options (SEL)..................5 Set the Clock (CLK)....................5 Change the Source (MODE)..................6 Mute on/off........................6... -
Page 3: Precautions
PRECAUTIONS Precautions & Warnings • To reduce the risk of fire, electric shock, and interfer-ence, do not attempt to repair this unit yourself. Refer all service to a qualified technician. • Some MP3/WMA files may not be playable. • Keep the volume at a reasonable level to avoid distracted driving. High volume levels may make it difficult to concentrate on traffic and road conditions while driving. -
Page 4: Installation
INSTALLATION Installation Opening This unit can be installed in any dashboard Having an opening as shown the right figure. 103 mm 182 mm If installation angle exceeds30 horizontal, the unit may not perform properly. To Install the Car Radio 1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery’s negative (-) terminal. -
Page 5: Electrical Connections
Electrical Connections WIRING DIAGRAM CAUTION +12V DC NEGATIVE GROUND 8. Front left PRE-AMP output (White) 9. Front right PRE-AMP output (Red) 10. Rear left PRE-AMP output (White) 11. Rear right PRE-AMP output (Red) 12. Radio antenna socket - Only use speakers with 4 ohms impedance. - Do not attach the control panel to the chassis before wiring is complete. - Page 6 Remove panel (power)/Volume knob and SEL (select/menu) button MODE (source) button 3. BAND(band) button (anser call) button 4. AMS (automatic store / preset station scan, automatic music search) button (pause/play), Preset station1 button 6. INT (intro) , Preset station 2 button 7.
-
Page 7: General Operation
GENERAL OPERATION Turn Unit On/Off • Press any button on the front panel or on the remote control to turn on the unit. • Press and hold the power ( ) button on the front panel or briefly press the power ( ) button on the remote control to turn the unit on or off. -
Page 8: Change The Source (Mode)
GENERAL OPERATION (CONT.) Change the Source (MODE) Press the MODE button to switch between RADIO, BT(Bluetooth), USB(with USB device inserted), CARD(with SD card inserted) and AUX-IN(auxiliary input) modes. Mute on/off In power on mode, briefly press the MUTE button to toggle mute on or off. The muted state will be also released when the volume knob is used. -
Page 9: Radio Operation
RADIO OPERATION Switch Between USA area and Europe area Frequency In radio mode, press the button to enter the switch state of the US(USA) and EU(europe) frequency, then rotate it to switch between US(USA) and EU(europe) frequency. The system will change the frequency setting in about 3 seconds. Change Bands (BAND) Press the BAND... -
Page 10: Usb/Sd Card Operation
USB / SD CARD OPERATION To insert USB / SD CARD • To play files in a USB device, leftwards slide the sliding door for USB port and insert the USB storage device into the USB port. Playback will begin automatically. •... -
Page 11: Auxiliary Input Operation
USB / SD CARD OPERATION (CONT.) eg.: If you want to listen to the 123rd song. a) Rotate the knob to select the “1” on the ones place, 2 seconds later, the “1" will skip to tens place. b) Rotate the knob to select the “2”... -
Page 12: Bluetooth Operation
2. When the phone finds the car audio system, the “SSL DDML28B” name will be displayed. 3. Choose the “SSL DDML28B” from the device list to pair and connect with the car audio system. Upon confirming, the BT logo will stop flashing. -
Page 13: Remote Control
REMOTE CONTROL Remove Insulating Sheet The remote control comes with an insulating sheet attached to the underside of the remote control, as illustrated on the right. The remote control will not work until the insulating sheet is removed. Replace Lithium Battery Cell 1. -
Page 14: Specifications
SPECIFICATIONS General Chassis Dimensions.............178(W) x 160(D) x 100(H) mm Power Supply Requirement ..................DC 12V Current Consumption ..................15A (max.) Maximum Power Output ..................60W x 4CH Radio USA/ Europe Frequency Range.........87.5 - 107.9 MHz (200KHz/Step) 87.5 - 108.0 MHz(50KHz/Step) Usable Sensitivity ....................30 dBu I.F. -
Page 15: Tr O U B L E S H O O T I N
TROUBLESHOOTING If you suspect something is wrong, immediately switch power off. Do not use the unit in abnormal condition, for example without sound, or with smoke or foul smell, can cause fire or electric shock. Immediately stop using it and call the store where you purchased it. Never try to repair the unit by yourself because it is dangerous to do so.