Related Manuals for Northern Industrial Tools 486910
Summary of Contents for Northern Industrial Tools 486910
- Page 1 STEEL SPRING-DRIVEN REEL OWNER’S MANUAL WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item# 486910...
-
Page 2: Intended Use
Thank you very much for choosing a NORTHERN TOOL + EQUIPMENT CO., INC. Product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. -
Page 3: Work Area
SAVE THESE INSTRUCTIONS WORK AREA Keep work area clean, free of clutter and well lit. Cluttered and dark work areas can cause å accidents. Do not use your hose reel where there is a risk of causing a fire or an explosion; e.g. in å... - Page 4 Compressed air only. Only use clean, dry and regulated compressed air at no more than 300 å PSI with this hose reel. Never use oxygen, carbon dioxide or any other bottled gas as a power source. Use proper size and type air pressure line and fittings. The recommended air line for this tool å...
-
Page 5: Installation Instructions
Personal Safety WARNING: Personal injury and/or equipment damage may result if proper safety precautions are not observed. Even low pressure is very dangerous and cause injury or death. 1. Ensure that reel is properly installed before connecting input and output hoses. 2. - Page 6 CAUTION: When adding hose, be careful not to exceed the winding mechanism’s spring capacity. Add just enough hose to achieve the desired tension. Damage to the winding mechanism will result if spring is over-tensioned 2. Adjusting the hose bumper Pull out the hose until the latch pawl is engaged. The hose bumper may be adjusted by loosening the slotted screws on the bumper.
- Page 7 2) To install the hose: a. Route the hose through the guide arm rollers and opening of the spool. Apply thread tape or sealant to hose threads. b. Screw hose fitting into threaded fitting on swivel. Tighten connection with a wrench on fitting. Install hose bumper on working end of hose if required.
-
Page 8: Parts List And Diagram
PARTS LIST AND DIAGRAM Description Quantity Description Quantity GUIDE PLATE SPRING WASHER BOLT WASHER BASE BOLT DOUBLE BOLT BRACKET ARM SPRING DOG WASHER SPRING RACHET DRUM WASHER SVIWLE SHAFT LOCK WASHER WASHER CLICK PULLEY O-RING WASHER LOCK WASHER LOCK WASHER WASHER SWIVEL SHAFT SHAFT... - Page 9 Northern Tool + Equipment Co., 2800 Southcross Drive West P.O. Box 1499 Burnsville, MN 55337-0499 Made in China Page 9 of 9...