Contents Short description ... 21 Important notes ... 25 What you must know! ... 25 Traffic safety ... 25 Installation/connection ... 25 Optical indication of theft protection ... 25 KeyCard ... 25 Replacing a KeyCard ... 26 Radio operation with RDS (Radio Data System) ...
Short description 1 Switching on: Press ON (the KeyCard has to be in- serted), the set plays with the pre-adju- sted volume. Switching off: Press ON for approximately 1 second. If the set was turned on by pressing ON, the KeyCard can be used for swit- ching the system on and off (KeyCard = passive anti-theft protection).
Page 5
6 Rocker switch Station search down in short up in short intervals intervals (when AF is off) (when AF is off) down Extra functions: Track CD operation Press briefly: to select the title. Hold down: CUE/REVIEW << >> To select the disc. In the DSC mode Select function and...
Page 6
; TA (Traffic Announcement) If “TA” lights up in the display, the sy- stem will only play traffic stations. To activate/deactivate the priority for traffic announcements: Press TA. < 1, 2, 3, 4, 5, 6 - preset buttons You can store 6 stations on each FM memory bank (I, II, and “T”) and another 6 stations on W and LW each.
Page 7
E AUD To adjust the treble and bass frequen- cies using the rocker button. Treble Bass Bass Treble The last setting will be automatically stored. If the setting remains unchanged within 8 seconds, the display will show the previous status. F lo To change the seek tuning sensitivity lo lit up in the display indicates normal...
Blaupunkt also offers designer KeyCards for an additional fee. You can find the service providers listed in the car radio service register ( ). In case of...
Replacing a KeyCard Any KeyCard can only be replaced by a new one with the same identification number (1 or 2). For example, to replace KeyCard 2, • insert KeyCard 1 into the set and turn it • Slightly push in the card so that it is released;...
Selecting the waveband With your car radio you can select between the following wavebands: FM 87.5 – 108 MHz MW 531 – 1602 kHz, and LW 153 – 279 kHz • Select the desired waveband by pres- sing the FM or M•L button.
Now the station is stored. The activated pre- set button is indicated in the display. Note: Should you tune into a station which has already been stored, the corresponding pre- set button and the memory bank will start flashing in the display for a short while, if you have selected another memory bank.
Reception of traffic announcements with RDS-EON Many FM broadcasters provide their service area with traffic messages at regular inter- vals. All traffic program stations transmit a special telegram signal in addition to the radio pro- gram, which is recognised and decoded by the car radio.
Tape operation Inserting a tape • Turn on the set. • Insert a tape. Eject Insert cassette with side A or 1 facing up, the open side facing cassette to the right The tape will be played in the direction used last.
Dolby B-NR* With this set you can play cassettes recorded with or without Dolby-B noise reduction. Cassettes recorded with Dolby NR* distin- guish by their reduced background noise and the improved dynamic characteristics. To switch Dolby on/off: • press B. When Dolby is on, “B” is indi- cated on the display.
DSC programming This car radio offers direct software control (DSC), which allows you to adapt a number of default settings to your preference and to store these values. In the following you will find an overview of all the default settings adjusted at the factory. To change a programmed parameter, •...
Page 16
LOUDNESS When listening at a low level, the loudness function will create a more natural sound by emphasizing the low fre- quency range. LOUD 1 - low boost LOUD 6 - strong boost SCANTIME Use this function to specify the scan time in the radio mode).
CD changer control (option) This car radio makes it possible to remote control a Blaupunkt CD changer: CDC-A03, -F03, -A05. Switching the CD mode on using SRC of the car radio Be sure that a CD magazine is inserted in the changer.
Enter/display CD names You can allocate names for up to 99 CDs. When playing a CD, the display will then give you entered name, e.g. VIVALDI. Precondition: NAME must be set under DSC - CD DISP. Entering a name: Be sure that at least 1 CD is inserted in the CD magazine.
Appendix Technical data Amplifier: Output power: 4 x 20 watts RMS acc. to DIN 45 324 4 x 25 watts music power acc. to DIN 45 324 0.9 µV at 26 dB FM sensitivity: S/N ratio Frequency response: 35 - 16,000 Hz (-3 dB) Cassette (metal) 30 - 16,000 Hz (-3 dB) Subject to modifications!