Summary of Contents for Femco WEATHERBRAKE 307022173
Page 1
INSTRUCTIONS WEATHERBRAKE 307022173 FITS MT295, MT297, MF1445, MF1455 & ST45 General Offices 1132 W. 1ST STREET McPherson, KS 67460 Phone: (620) 241-3513 Web: www.femcomfg.com Form No. 286324200 / 11-2005...
Page 2
IMPORTANT CAREFULLY STUDY THE PHOTO DIAGRAMS SHOWING THE LOCATION OF EACH PART. LEAVE ALL HARDWARE LOOSE UNTIL INSTRUCTED TO TIGHTEN. YOKE BRACKETS 1. Attach yoke brace (A) to tubing using four (4) M8 bolts. 2. Attach yoke brackets (B) to yoke brace using two (2) 1/4”...
MOTOR COVER 1. Arrange motor cover over hood of tractor. 2. Slide 3” hem of motor cover down over top of door post. YOKE 1. Insert yoke (A) into top 3” hem of motor cover. 2. Attach yoke to yoke bracket using two (2) 1/4” x 3/4” bolts and nuts 3.
Page 4
TIE STRAPS 1. Thread cloth strap through grommets at bottom of mo- tor cover and tie. 2. Route cloth straps to other side or to a point on tractor and tie. IMPORTANT Cloth straps are not to be attached to any moving, ro- tating, or heat generating points of tractor.
DOORS 1. Locate holes in door post and cut holes in the fabric. 2. Hold door (A) to door post and bottom of the wind- shield. 3. Mark location of holes in the door post to the door. 4. Cut 5/8” slots next to wire frame of door and attach to door post using four (4) #10 x 3/4”...
DOOR LATCH 1. Assemble door latches as shown using two (2) 1/4” x 3/4” bolts and nuts. 2. Position under bottom rear of door. 3. Door is to be set firmly in loop of door latch. Change position up or down with adjustment holes if necessary. 4.