Picture Id - LG 32SE3D Owner's Manual
Digital signage (monitor signage)
Hide thumbs
Also See for 32SE3D:
- Owner's manual (135 pages) ,
- Quick start manual (12 pages) ,
- Easy setup manual (11 pages)
Table of Contents
Picture ID
AUDIO
(RGB/DVI)
RS-232C OUT
Picture ID is used to change the settings of a specific set (display) using a single IR receiver for multi-vision.
Communication is possible between a monitor with an IR receiver and other monitors using RS-232C cables. Each
RS-232C IN
REMOTE
monitor is identified by a Set ID. Setting Picture ID allows you to only use the remote control with monitors with a Set
CONTROL IN
ID that matches the Picture ID.
1
Assign Set ID to the installed monitors as shown below:
2
Press the red Picture ID On button on the remote control.
3
Make sure that the Picture ID you set is identical to the Set ID of the monitory you wish to control.
•
A set with a Set ID that is different from the Picture ID cannot be controlled by IR signals.
NOTE
•
If Picture ID has been set to 2, only the upper right monitor, which has a Set ID of 2, can be controlled by IR signals.
If you press the green Picture ID Off button on your remote control, the Picture ID for all monitors are turned off. If
•
you then press any button on the remote control, all monitors can be controlled by IR signals regardless of their Set
ID's.
RS-232C OUT
RS-232C OUT
RS-232C IN
RS-232C IN
47
Hide quick links:
Chapters
Table of Contents
