Table of Contents
ED-DCX8510-4 and
ED-DCX-4S-B
Figure 42
Installing the Ethernet Hub
Plug the "right angle" (L) connectors into the system as shown: Cable
from LEFT SIDE into top (PS1). Cable from RIGHT SIDE to bottom
(PS2).
Connectors' positioning for ED-DCX8510-4 and ED-DCX-4S-B
The ethernet hub installs with two mounting ears on the hub chassis
and attaches to the cabinet via 2 screws
the left and right side vertical mounting rails in the top U of the
cabinet.
Note: The ethernet hub (model # SP-HUB-ETH) in the EC-1700-B is an
optional item. If no ethernet hub was ordered then connect the ethernet
cables directly to the customer's network ports. If the hub is installed in the
cabinet, then connect them as described below. Note prenumbered ethernet
cables are not included the cabinet. The customer will need to provide
standard CAT-5 ethernet cables.
Connect the hub cables to the director as follows:
For one director:
◆
• Dress the connected ethernet cables through the circular
opening in the cable management tray
Installing Directors into the EC-1700 Cabinet
(Figure
43) and clip nuts on
(Figure 44 on page
Installing B Series directors
65).
63
Hide quick links:
Table of Contents
