Table of Contents
Troubleshooting
Problem
No image or wrong image on TV1
No image or wrong image on TV2
Interference in the image on TV2
The video sources do not respond • Point the remote control directly to the receiver (B).
to the remote control commands
from TV2
The image of the video source
disappears on TV2
Tip
• Make sure video sources are connected to the transmitter (A).
• Make sure the transmitter (A) is connected to TV1.
• Make sure SCART cables are firmly inserted.
• Make sure the video source is switched on.
• Make sure the correct SCART input on TV1 is selected.
• Select the correct video source with TV1 source.
> See the user manual (H) page 8.
• Make sure SCART cables are firmly inserted.
• Make sure the receiver (B) is connected to TV2.
• Make sure both receiver (B) and transmitter (A) are switched on.
• Make sure the video source is switched on.
• Make sure the correct SCART input on TV2 is selected.
• Select the correct video source with +/- on the receiver (B).
• If the video source gives proper image on TV1:
Make sure the video source gives video signal in CVBS mode.
> See its user manual
• Change the wireless channel that is used for communication.
> See the user manual (H) page 7.
• The receiver (B) is out of range of the transmitter (A).
The number of walls and ceilings in between the receiver (B) and
transmitter (A) restrict the distance.
• Slightly change the position of the receiver (B) or the transmitter (A).
• Change the wireless channel that is used for communication.
> See the user manual (H) page 7.
• The receiver (B) is out of range of the transmitter (A).
The number of walls and ceilings in between the receiver (B) and
transmitter (A) restrict the distance.
• Replace the batteries of the remote controls with new ones.
• Install the remote control blaster cord (G).
> See the user manual (H) page 6.
• The maximum operating distance of the remote control is 5 m.
• Turn off the auto standby mode of the video source.
> See its user manual.
• Follow the instructions to reconnect the videosources.
> See this quick start guide (F).
Table of Contents
