Quick Links
Vanish XL
Figure 1
EAS Handle
S
Locknut
Figure 2
Washer P
O
Bu on Head
Socket Bolt
N
Vanish XL
Rear Pivot Arm Vanish XL
D
Front Pivot Arm
C
Figure 3
Smartop VanishXL 190409
Step #1
Position the Smartop (in closed position) on the spa making sure that all four
EAS Bracket
corners are properly positioned and square on the spa.
Step #2
Attach the EAS handle to the EAS bracket using the supplied 5/16 x 1-1/4"
button head socket bolt (see Fig. 1).
Step #3
Attach the Vanish XL pivot arms to the Smartop using the supplied button head
socket bolts and let the assembly hang freely (see Fig. 2). Note: Make sure to run
the bolts from the inside out. The locknuts need to be facing outwards. Also, make
sure to use the supplied plastic washers as a spacer in between the metal plate on the
Bu on Head
pivot arms and the Vanish XL cover mounting bracket. Do not overtighted bolts,
Socket Bolt
the pivot arms must rotate freely.
N
Step #4
Swing the Vanish XL bracket assembly forward making sure the two pivot
Vanish XL Cover
arms rest against each other (see Fig. 2). Attach the Vanish XL bracket
Moun ng Bracket
assembly to the spa cabinet using the supplied #10 x 1-1/2" mounting
B
screws. Note: make sure to put downward pressure on the Smartop when
attaching theVanish XL bracket assembly to the spa cabinet to ensure the
Smartop is making a good seal with the acrylic of the spa.
Step #5
Repeat steps 2 & 3 for the opposite side of the spa.
Step #6
To attach the shocks to the bracket assembly, partially open your Smartop cover
and snap the shocks onto the appropriate ball studs (see Fig. 3). Note: make sure
the black body of the shock is pointing towards the middle of the Smartop.
Step #7
Open the Smartop so it is in the fully upright position. Using the supplied #10
x 1-1/2" mounting screws, finish attaching the Vanish XL bracket assembly to
the spa.
Vanish XL
Step #8
Base Bracket
Attach the Vanish XL cover plate to the bracket assembly using the supplied
A
pancake head self-tapping screws. Next, thread the 3/8 x 3/4" hex cap bolt
through the hole in the cover plate that lines up with the rear pivot arm (see
Fig. 4). Note: Do not overtighten hex cap bolt.
Figure 4
Shocks
Y
X
Hex Cap
Bolt
Installation Instructions - Updated as of 04/09/19
R
Side Tub Lock
Assembly
(Rear of Spa)
Z
V
Pancake Head
Self-Tapping
Screws
Page 1
Related Manuals for Leisure Concepts SMARTOP Vanish XL
Summary of Contents for Leisure Concepts SMARTOP Vanish XL
- Page 1 Vanish XL Installation Instructions - Updated as of 04/09/19 Step #1 Figure 1 Position the Smartop (in closed position) on the spa making sure that all four EAS Bracket corners are properly positioned and square on the spa. Step #2 Attach the EAS handle to the EAS bracket using the supplied 5/16 x 1-1/4”...
- Page 2 Step #9 Step #10 Attach the side tub lock cable assembly to the pre-installed tub lock If the thermal seal on the underside of the Smartop does not completely bracket on the side of the aluminum trim on the Smartop and turn seal around the control panel of your spa, an additional thermal seal the knob to lock it in place.