GE PDW8900 Series Quick Start
Smartdispense system
Hide thumbs
Also See for PDW8900 Series:
- Owner's manual (48 pages) ,
- Technical service manual (37 pages) ,
- Installation instructions manual (18 pages)
Available languages
Available languages
Quick Links
A Quick Start to Your
SmartDispense System
Smart Dispense
LOW DETERGENT
S
ENSING
W
ASHING
Water hardness test strip indication
SOFT
0 RED
1 RED
2 RED
3 RED
4 RED
HARD
Pub. No. 49-5985
Part No. 165D4700P309
04-05 JR
Before You Start
The SmartDispense system can only be used with LIQUID detergent
designed for use in an automatic dishwasher.
Opening the SmartDispense Cap
To open the cap covering the SmartDispense reservoir, push down on the
cap and turn counterclockwise. It takes approximately 2 full turns to
disengage the cap from the reservoir in the door. If you do not push
down, the cap will spin freely and not loosen from the reservoir.
When the cap is removed, set it on the countertop.
Filling the SmartDispense Reservoir
Set the door at a comfortable angle (approximately 30 to 45 degrees from
full open).
Aim the liquid dishwasher detergent bottle at the opening in the door
and begin to fill. Fill the reservoir until the detergent just starts to build
up on the threads of the reservoir access.
The detergent reservoir in the door has the capacity to hold 47 fluid
ounces of liquid dishwasher detergent.
Closing the SmartDispense Reservoir
To close the SmartDispense reservoir, place the cap over the top of
the access hole and turn clockwise until the cap is tight. Insufficient
tightening could lead to a leak.
SmartDispense Detergent Level Sensor
There is a light indicator on the control panel that will signal when the
D
RYING
detergent reservoir is low. The light will turn on when the low level is
S
ANITIZED
indicated. When this happens, you will have between 3 and 7 wash cycles
C
LEAN
left before the detergent reservoir is completely empty.
Calibrating Water Hardness
The SmartDispense system will optimize detergent dosage during the wash
Value to Enter
cycle based on water hardness.
into Dishwasher
Follow the directions on the water hardness test strip provided with the
1
dishwasher to determine the hardness of water in your home.
2
The default water hardness setting programmed into the dishwasher
3
is "Soft." If the test strip indicates you have hard water, follow the
4
instructions in the Use and Care manual to adjust the setting accordingly.
5
G E P r o f i l e D i s h w a s h e r
P D W 8 9 0 0 S e r i e s
P D W 9 7 0 0 S e r i e s
P D W 9 9 0 0 S e r i e s
Related Manuals for GE PDW8900 Series
Summary of Contents for GE PDW8900 Series
- Page 1 A Quick Start to Your G E P r o f i l e D i s h w a s h e r P D W 8 9 0 0 S e r i e s SmartDispense System P D W 9 7 0 0 S e r i e s P D W 9 9 0 0 S e r i e s Before You Start The SmartDispense system can only be used with LIQUID detergent...
- Page 2 Un démarrage rapide pour votre G E P r o f i l e L a v e - v a i s s e l l e S é r i e P D W 8 9 0 0 système SmartDispense S é...